Arduino入门：在Tinkercad模拟网站上制作一个流水灯

电路连接如图所示：

---

---

 源代码如下：

void setup()
{
  pinMode(1,OUTPUT);//output pin 1
  pinMode(2,OUTPUT);//output pin 2
  pinMode(3,OUTPUT);//output pin 3
  pinMode(4,OUTPUT);//output pin 4
  pinMode(5,OUTPUT);//output pin 5
  pinMode(6,OUTPUT);//output pin 6
}

void loop()
{
  digitalWrite(1, HIGH);
  delay(1000); // Wait for 1000 millisecond(s)
  digitalWrite(1, LOW);
  delay(1000); // Wait for 1000 millisecond(s)
  digitalWrite(2, HIGH);
  delay(1000); // Wait for 1000 millisecond(s)
  digitalWrite(2, LOW);
  delay(1000); // Wait for 1000 millisecond(s)
  digitalWrite(3, HIGH);
  delay(1000); // Wait for 1000 millisecond(s)
  digitalWrite(3, LOW);
  delay(1000); // Wait for 1000 millisecond(s)
  digitalWrite(4, HIGH);
  delay(1000); // Wait for 1000 millisecond(s)
  digitalWrite(4, LOW);
  delay(1000); // Wait for 1000 millisecond(s)
  digitalWrite(5, HIGH);
  delay(1000); // Wait for 1000 millisecond(s)
  digitalWrite(5, LOW);
  delay(1000); // Wait for 1000 millisecond(s)
  digitalWrite(6, HIGH);
  delay(1000); // Wait for 1000 millisecond(s)
  digitalWrite(6, LOW);
  delay(1000); // Wait for 1000 millisecond(s)
}