南邮最新电装实习ESP8266 源码

呼吸灯：

from machine import Pin, Timer, PWM 
LED = PWM(Pin(4)) p = 0 dp = 10 def LED_set(t):     
global p, dp  
LED.duty(p)     
p += dp     
if p == 0 or p > 1023 - dp:         
dp = -dp 
tm =Timer(1) 
tm.init(period = 10, mode = Timer.PERIODIC, callback = LED_set) 

舵机：

import machine 
import time 
pwm_duoji = machine.PWM(machine.Pin(14)) 
pwm_duoji .freq(50) def set_servo_angle(angle):     
duty = int(((angle / 18) * 10)+20)     
pwm_duoji.duty(duty)     
time.sleep_ms(500) 
angles = [0, 45, 90, 135, 180] for angle in angles:     
set_servo_angle(angle)     
utime.sleep(1) servo.deinit() 

8266加入学校网络：

import network
ssid = "NJUPT"  
password = "123"  
sta_if = network.WLAN(network.STA_IF)
sta_if.active(True)
sta_if.connect(ssid, password)
while not sta_if.isconnected():
    pass
print("Connected to Wi-Fi")
print("IP address:", sta_if.ifconfig()[0])
print("Subnet mask:", sta_if.ifconfig()[1])
print("Gateway:", sta_if.ifconfig()[2])

热点模式Ping：

import network
import time
ap = network.WLAN(network.AP_IF)
ap.active(True)
ap.config(essid="学号", password="学号")
ip_address = ap.ifconfig()[0]
print("热点IP地址:", ip_address)
time.sleep(10)

显示温湿度：

import machine
import dht
import ssd1306
import utime
dht_pin = machine.Pin(12)
oled_sda_pin = machine.Pin(13)
oled_scl_pin = machine.Pin(14)
oled_width = 128
oled_height = 64
dht_sensor = dht.DHT11(dht_pin)
i2c = machine.I2C(sda=oled_sda_pin, scl=oled_scl_pin)
oled = ssd1306.SSD1306_I2C(oled_width, oled_height, i2c)
while True:
    oled.fill(0)
    oled.text("学号", 0, 0)
    dht_sensor.measure()
    temperature = dht_sensor.temperature()
    humidity = dht_sensor.humidity()
    oled.text("Temperature:", 0, 16)
    oled.text(str(temperature) + "C", 0, 32)
    oled.text("Humidity:", 0, 48)
    oled.text(str(humidity) + "%", 0, 64)
    oled.show()
    utime.sleep(2)