使用rt-thread studio配置STM32F103RET6的多串口流程

最新推荐文章于 2024-04-21 05:56:42 发布

VIP文章《大树》

最新推荐文章于 2024-04-21 05:56:42 发布

阅读量543

点赞数

分类专栏： rt-thread STM32 文章标签： stm32 单片机 arm

本文链接：https://blog.csdn.net/q35126156/article/details/126503534

版权

一、配置串口

1.进入RT-Thread Setting将serial模块打开

2.一般都使用DMA模式，继续进入serial，打开DMA模式，保存。

3.进入board.h文件，进行使用的串口宏配置

/*-------------------------- UART CONFIG BEGIN --------------------------*/

/** After configuring corresponding UART or UART DMA, you can use it.
 *
 * STEP 1, define macro define related to the serial port opening based on the serial port number
 *                 such as     #define BSP_USING_UART1
 *
 * STEP 2, according to the corresponding pin of serial port, define the related serial port information macro
 *                 such as     #define BSP_UART1_TX_PIN       "PA9"
 *                             #define BSP_UART1_RX_PIN       "PA10"
 *
 * STEP 3, if you want using SERIAL DMA, you must open it in the RT-Thread Settings.
 *                 RT-Thread Setting -> Components -> Device Drivers -> Serial Device Drivers -> Enable Serial DMA Mode
 *
 * STEP 4, according to serial port number to define serial port tx/rx DMA function in the board.h file
 *                 such as     #define BSP_UART1_RX_USING_DMA
 *
 */

//Debug
#define BSP_USING_UART1
#define BSP_UART1_TX_PIN       "PA9"
#define BSP_UART1_RX_PIN       "PA10"
#define BSP_UART1_RX_USING_DMA

//通信端口
#define BSP_USING_UART2
#