Rk3399-Linux-麒麟-EDP屏幕调试

Rk3399-Linux-麒麟-EDP屏幕调试

EDP 屏幕主要是对设备树进行配置，并设置连接的显示的vop

主要参考瑞星微的文档，在sdk的doc目录下可以找到。Rockchip_DRM_Panel_Porting_Guide_V1.6_20190228.pdf

需要注意的点，enable-gpio和power-supply 电源控制，
如果是直接供电就不需要power-supply

屏幕配置

panel: panel {
compatible = “simple-panel”;
backlight = <&backlight>;
status = “okay”;
//power-supply = <&vcc_lcd>;
enable-gpios = <&gpio1 RK_PB5 GPIO_ACTIVE_HIGH>;
bus-format = <MEDIA_BUS_FMT_RGB666_1X18>;
bpc = <6>;
prepare-delay-ms = <210>;
enable-delay-ms = <210>;
display-timings {
native-mode = <&timing0>;

		timing0: timing0 {
                  	clock-frequency = <72000000>;
                    hactive = <1366>;
                    vactive = <768>;
                    hfront-porch = <14>;
                    hsync-len = <56>;
                    hback-porch = <64>;
                    vfront-porch = <1>;
                    vsync-len = <3>;
                    vback-porch = <28>;
                    hsync-active = <0>;
                    vsync-active = <0>;
                    de-active = <0>;
                    pixelclk-active = <0>;
            };
	};

	ports {
		panel_in: endpoint {
			remote-endpoint = <&edp_out>;
		};
	};
};

其中这两个项需要看EPD屏幕的参数来确定是6位或8位的，
display-timings 中的值也需要根据屏幕参数确定，这个都要看屏幕给的datasheet确定。

EDP配置

&edp {
status = “okay”;
force-hpd;
//enable-delay-ms = <200>;
ports {
port@1 {
reg = <1>;
#address-cells = <1>;
#size-cells = <0>;
edp_out: endpoint {
remote-endpoint = <&panel_in>;
};
};
};
};

&edp_in_vopb {
status = “disabled”;
};

&edp_in_vopl {
status = “okay”;
};

&route_edp{
status = “okay”;
connect = <&vopl_out_edp>;
};

上边是Edp的配置，让edp显示在vopl中，

关于vopb和vopl的介绍可以参考瑞信微的文档