STM32CubeMx配置WKUP（PA0）按键低功耗唤醒

任务目标

配置wakeup唤醒低功耗，上电灯亮5秒后关闭，进入低功耗模式；若未进入低功耗则会灯闪烁；当按下wakeup则唤醒MCU。

CubeMx配置

PA0配置wakeup唤醒

配置LED指示灯

别的无需配置。

代码

int main(void)
{
  /* USER CODE BEGIN 1 */

  /* USER CODE END 1 */

  /* MCU Configuration--------------------------------------------------------*/

  /* Reset of all peripherals, Initializes the Flash interface and the Systick. */
  HAL_Init();

  /* USER CODE BEGIN Init */

  /* USER CODE END Init */

  /* Configure the system clock */
  SystemClock_Config();

  /* USER CODE BEGIN SysInit */

  /* USER CODE END SysInit */

  /* Initialize all configured peripherals */
  MX_GPIO_Init();
  /* USER CODE BEGIN 2 */
	LED(0);
  __HAL_RCC_PWR_CLK_ENABLE();//使能PWR时钟
  if (__HAL_PWR_GET_FLAG(PWR_FLAG_SB) != RESET)//检查并检查系统是否从待机模式恢复
  {
    /* Clear Standby flag */
    __HAL_PWR_CLEAR_FLAG(PWR_FLAG_SB);
  }
  HAL_Delay(5000);
	LED(1);
  HAL_PWR_DisableWakeUpPin(PWR_WAKEUP_PIN1);//禁用所有使用的唤醒源:PWR_WAKEUP_PIN1 connected to PA.00
  __HAL_PWR_CLEAR_FLAG(PWR_FLAG_WU);//清除所有相关的唤醒标志
  HAL_PWR_EnableWakeUpPin(PWR_WAKEUP_PIN1);//启用连接到PA.00的WakeUp Pin
  HAL_PWR_EnterSTANDBYMode();//进入待机模式
  /* USER CODE END 2 */

  /* Infinite loop */
  /* USER CODE BEGIN WHILE */
  while (1)
  {
    /* USER CODE END WHILE */

    /* USER CODE BEGIN 3 */
		HAL_Delay(500);
		LED_TURN();
  }
  /* USER CODE END 3 */
}

注：待机模式相当于MCU复位重启！