WRF模式输出变量

float LU_INDEX(Time, south_north, west_east) ;
LU_INDEX:description = “LAND USE CATEGORY” ;
LU_INDEX:units = “” ;
土地利用类型（如城市、植被、湖泊等）

float ZNU(Time, bottom_top) ;
ZNU:description = “eta values on half (mass) levels” ;
ZNU:units = “” ;
eta半层（质量点）坐标值

float ZNW(Time, bottom_top_stag) ;
ZNW:description = “eta values on full (w) levels” ;
ZNW:units = “” ;
eta整层（w点）坐标值

float ZS(Time, soil_layers_stag) ;
ZS:description = “DEPTHS OF CENTERS OF SOIL LAYERS” ;
ZS:units = “m” ;
土壤层各层中间的深度

float DZS(Time, soil_layers_stag) ;
DZS:description = “THICKNESSES OF SOIL LAYERS” ;
DZS:units = “m” ;
土壤层厚度

float U(Time, bottom_top, south_north, west_east_stag) ;
U:description = “x-wind component” ;
U:units = “m s-1” ;
x方向风分量

float V(Time, bottom_top, south_north_stag, west_east) ;
V:description = “y-wind component” ;
V:units = “m s-1” ;
y方向风分量

float W(Time, bottom_top_stag, south_north, west_east) ;
W:description = “z-wind component” ;
W:units = “m s-1” ;
垂直风分量

float PH(Time, bottom_top_stag, south_north, west_east) ;
PH:description = “perturbation geopotential” ;
PH:units = “m2 s-2” ;
扰动位势高度

float PHB(Time, bottom_top_stag, south_north, west_east) ;
PHB:description = “base-state geopotential” ;
PHB:units = “m2 s-2” ;
基准态位势高度

float T(Time, bottom_top, south_north, west_east) ;
T:description = “perturbation potential temperature (theta-t0)” ;
T:units = “K” ;
扰动位温（theta-t0）

float MU(Time, south_north, west_east) ;
MU:description = “perturbation dry air mass in column” ;
MU:units = “Pa” ;
柱内扰动干空气质量

float MUB(Time, south_north, west_east) ;
MUB:description = “base state dry air mass in column” ;
MUB:units = “Pa” ;
柱内基准态干空气质量

float NEST_POS(Time, south_north, west_east) ;
NEST_POS:description = “-” ;
NEST_POS:units = “-” ;
作多层嵌套时粗（母）网格位置

float P(Time, bottom_top, south_north, west_east) ;
P:description = “perturbation pressure” ;
P:units = “Pa” ;
扰动气压

float PB(Time, bottom_top, south_north, west_east) ;
PB:description = “BASE STATE PRESSURE” ;
PB:units = “Pa” ;
基准态气压

float SR(Time, south_north, west_east) ;
SR:description = “fraction of frozen precipitation” ;
SR:units = “-” ;
固体降水比例

float POTEVP(Time, south_north, west_east) ;
POTEVP:description = “accumulated potential evaporation” ;
POTEVP:units = “W m-2” ;
累计的潜在蒸发

float SNOPCX(Time, south_north, west_east) ;
SNOPCX:description = “snow phase change heat flux” ;
SNOPCX:units = “W m-2” ;
雪相态改变的热通量

float SOILTB(Time, south_north, west_east) ;
SOILTB:description = “bottom soil temperature” ;
SOILTB:units = “K” ;
土壤底部温度

float FNM(Time, bottom_top) ;
FNM:description = “upper weight for vertical stretching” ;
FNM:units = “” ;
作垂直方向展开时上层权重

float FNP(Time, bottom_top) ;
FNP:description = “lower weight for vertical stretching” ;
FNP:units = “” ; 作垂直方向展开时下层权重

float RDNW(Time, bottom_top) ;
RDNW:d