Arduino的模拟输出-analogWrite()

最新推荐文章于 2025-02-11 15:47:56 发布

weixin_30460489

最新推荐文章于 2025-02-11 15:47:56 发布

阅读量6.6k

点赞数 2

原文链接：http://www.cnblogs.com/baiji/p/10837259.html

版权

本文详细介绍了Arduino的analogWrite()函数，该函数用于在指定的管脚输出PWM波，以实现LED亮度调节或电机速度控制。PWM信号频率约为490Hz。analogWrite()在不同Arduino板上的支持引脚有所不同，通常包括3, 5, 6, 9, 10, 11等。注意，该函数不影响模拟引脚或analogRead()。此外，引脚5和6在低占空比设置时可能会有高于预期的占空比。" 68485648,6569381,C语言实现堆排序算法详解,"['排序算法', '数据结构', 'C语言', '算法实现']

摘要生成于 C知道，由 DeepSeek-R1 满血版支持，前往体验 >

analogWrite()

Description 介绍

Writes an analog value (PWM wave) to a pin. Can be used to light a LED at varying brightnesses or drive a motor at various speeds. After a call to analogWrite(), the pin will generate a steady square wave of the specified duty cycle until the next call to analogWrite() (or a call to digitalRead() or digitalWrite() on the same pin). The frequency of the PWM signal is approximately 490 Hz.

将模拟值（PWM波）输出到管脚。可用于在不同的光线亮度调节发光二极管亮度或以不同的速度驱动马达。调用analogWrite()后，该引脚将产生一个指定占空比的稳定方波，直到下一次调用analogWrite()（或在同一引脚调用digitalRead()或digitalWrite()）。 PWM的信号频率约为490赫兹。

On most Arduino boards (those with the ATmega168 or ATmega328), this function works on pins 3, 5, 6, 9, 10, and 11. On the Arduino Mega, it works on pins 2 through 13. Older Arduino boards with