matlab 如何画ladder图,Generate Ladder Diagram code from Stateflow chart

In the ladder diagram, when the output coil corresponding to

the active state is turned on, reset coils can be used to force deactivation

of other states. The reset coils act as a safeguard against multiple

states being simultaneously active. Specify whether the reset coils

must be generated.If you do not enable this option, each output is a

coil that represents a state in the chart.

The following figure shows an output of the diagram when imported

into the CODESYS 3.5 IDE. The output coil represents a state A1 in

the chart. When the state is active, the coil receives power.

If you enable this option, each output is a coil that

represents a state of the chart. The output is also coupled with reset

coils that represent the other states. When a particular state is

active, the reset coils force deactivation of the other states.

The following figure shows an output in the ladder diagram when

viewed in the CODESYS 3.5 IDE. The output coil represents a state A1.

To avoid multiple states from being simultaneously active, the signal

that turns the coil on also turns on the reset coils associated with

the other states A2, A3 and A4.