ELM327全指令 中文翻译对应。
@1
display the device description General 显示设备描叙兼容ELM327用
AL
Allow Long (>7 byte) messages OBD 允许长达255字节(本指令为兼容ELM327而设)
AR
Automatic Receive OBD 自动设定接收地址
AT0
Adaptive Timing Off OBD
AT1
Adaptive Timing Auto1 OBD
AT2
Adaptive Timing Auto2 OBD
BD
perform a Buffer Dump OBD 返回接收缓冲区数据
BI
Bypass the Initialization sequence OBD 绕开OBD总线的初始化过程
BRD hh
try Baud rate Divisor hh General 测试RS232波特率
BRT hh
set Baud Rate handshake Timeout General 变更RS232波特率时的溢出时间
CAF0
CAN Automatic Formatting Off CAN
CAF1
CAN Automatic Formatting On CAN
CF hh hh hh hh
set the ID Filter to hhhhhhhh CAN
CF hhh
set the ID Filter to hhh CAN
CFC0
CAN Flow Control Off CAN
CFC1
CAN Flow Control On CAN
CM hh hh hh hh
set the ID Mask to hhhhhhhh CAN
CM hhh
set the ID Mask to hhh CAN
CP hh
set CAN Priority (only for 29 bit) CAN
CRA hhh
set CAN Receive Address to hhh CAN
CRA hhhhhhhh
set CAN Receive Address to hhhhhhhh CAN
CS
show the CAN Status CAN
CV dddd
Calibrate the Voltage to dd.dd volts Volts
D
set all to Defaults General
D0
display of the DLC Off CAN
D1
display of the DLC On CAN
DM1 (J1939)
Monitor for DM1 messages J1939
DP
Describe the current Protocol OBD 返回当前协议名称
DPN
Describe the Protocol by Number OBD 返回当前协议编号(数字)
E0
Echo Off General 关闭发送命令的回传
E1
Echo On General 打开发送命令的回传
FC SD [1-5 bytes]
Flow Control Set Data to […] CAN
FC SH hh hh hh hh
Flow Control Set the Header to hhhhhhhh CAN
FC SH hhh
Flow Control Set the Header to hhh CAN
FC SM h
Flow Control Set the Mode to h CAN