STM32HAL库ADC实验（二）——连续采样模式打印电压值

int main(void)
{
  /* USER CODE BEGIN 1 */
	uint16_t adcData;
	float voltage;
  /* USER CODE END 1 */

  /* MCU Configuration--------------------------------------------------------*/

  /* Reset of all peripherals, Initializes the Flash interface and the Systick. */
  HAL_Init();

  /* USER CODE BEGIN Init */

  /* USER CODE END Init */

  /* Configure the system clock */
  SystemClock_Config();

  /* USER CODE BEGIN SysInit */

  /* USER CODE END SysInit */

  /* Initialize all configured peripherals */
  MX_GPIO_Init();
  MX_DMA_Init();
  MX_ADC3_Init();
  MX_USART1_UART_Init();
  /* USER CODE BEGIN 2 */
	  HAL_ADC_Start (&hadc3 );

  /* USER CODE END 2 */

  /* Infinite loop */
  /* USER CODE BEGIN WHILE */
  while (1)
  {
    /* USER CODE END WHILE */
      HAL_Delay(500);
	  HAL_ADC_PollForConversion (&hadc3 ,100);
	  adcData =HAL_ADC_GetValue(&hadc3 );

//	  printf ("%f \t\n\r",adcData );
	  printf ("%d \t\n\r",adcData);
    /* USER CODE BEGIN 3 */
  }
  /* USER CODE END 3 */
}

连续采样就是start ADC之后，会一直采样，你去读他就行了，但是会偶尔占用内存，做项目不推荐。
但是可以随时停止
HAL_ADC_Stop (&hadc3 );