H3C单臂路由的配置

（一）目的

  通过路由器的路由功能实现不同 VLAN 之间的互通。

（二）网络拓扑图

（三）配置步骤

1.配置pc1，pc2，pc3的ip地址和网关

2.sw1的配置

[sw1]vlan 10
[sw1-vlan10]port GigabitEthernet 1/0/1
[sw1]vlan 20
[sw1-vlan20]port GigabitEthernet 1/0/2
[sw1]vlan 30
[sw1-vlan30]port GigabitEthernet 1/0/3
[sw1]interface GigabitEthernet 1/0/9
[sw1-GigabitEthernet1/0/9]port link-type trunk
[sw1-GigabitEthernet1/0/9]port trunk permit vlan all
 

3.r1的配置
[r1]interface GigabitEthernet 0/0.1
[r1-GigabitEthernet0/0.1]vlan-type dot1q vid 10
[r1-GigabitEthernet0/0.1]ip add 192.168.10.1 24
[r1-GigabitEthernet0/0.1]qu
[r1]interface GigabitEthernet 0/0.2
[r1-GigabitEthernet0/0.2]vlan-type dot1q vid 20
[r1-GigabitEthernet0/0.2]ip address 192.168.20.1 24
[r1-GigabitEthernet0/0.2]qu
[r1]interface GigabitEthernet 0/0.3
[r1-GigabitEthernet0/0.3]vlan-type dot1q vid 30
[r1-GigabitEthernet0/0.3]ip address 192.168.30.1 24
[r1-GigabitEthernet0/0.3]qu
[r1]

4.验证

用pc1来ping 192.168.10.1 

              ping192.168.20.2

              ping192.168.30.2