esp32 gpio

最新推荐文章于 2024-09-07 19:37:41 发布

wwwlyj123321

最新推荐文章于 2024-09-07 19:37:41 发布

阅读量252

点赞数

分类专栏： esp8266 文章标签：物联网

本文链接：https://blog.csdn.net/wwwlyj123321/article/details/127299659

版权

esp8266 专栏收录该内容

8 篇文章 0 订阅

订阅专栏

typedef struct {
    uint64_t pin_bit_mask;          /*!< GPIO pin: set with bit mask, each bit maps to a GPIO */
    gpio_mode_t mode;               /*!< GPIO mode: set input/output mode                     */
    gpio_pullup_t pull_up_en;       /*!< GPIO pull-up                                         */
    gpio_pulldown_t pull_down_en;   /*!< GPIO pull-down                                       */
    gpio_int_type_t intr_type;      /*!< GPIO interrupt type                                  */
} gpio_config_t;

typedef enum {
    GPIO_MODE_DISABLE = GPIO_MODE_DEF_DISABLE,                                                         /*!< GPIO mode : disable input and output             */
    GPIO_MODE_INPUT = GPIO_MODE_DEF_INPUT,                                                             /*!< GPIO mode : input only                           */
    GPIO_MODE_OUTPUT = GPIO_MODE_DEF_OUTPUT,                                                           /*!< GPIO mode : output only mode                     */
    GPIO_MODE_OUTPUT_OD = ((GPIO_MODE_DEF_OUTPUT) | (GPIO_MODE_DEF_OD)),                               /*!< GPIO mode : output only with open-drain mode     */
    GPIO_MODE_INPUT_OUTPUT_OD = ((GPIO_MODE_DEF_INPUT) | (GPIO_MODE_DEF_OUTPUT) | (GPIO_MODE_DEF_OD)), /*!< GPIO mode : output and input with open-drain mode*/
    GPIO_MODE_INPUT_OUTPUT = ((GPIO_MODE_DEF_INPUT) | (GPIO_MODE_DEF_OUTPUT)),                         /*!< GPIO mode : output and input mode                */
} gpio_mode_t;

typedef enum {
    GPIO_PULLUP_DISABLE = 0x0,     /*!< Disable GPIO pull-up resistor */
    GPIO_PULLUP_ENABLE = 0x1,      /*!< Enable GPIO pull-up resistor */
} gpio_pullup_t;

typedef enum {
    GPIO_PULLDOWN_DISABLE = 0x0,   /*!< Disable GPIO pull-down resistor */
    GPIO_PULLDOWN_ENABLE = 0x1,    /*!< Enable GPIO pull-down resistor  */
} gpio_pulldown_t;

typedef enum {
    GPIO_INTR_DISABLE = 0,     /*!< Disable GPIO interrupt                             */
    GPIO_INTR_POSEDGE = 1,     /*!< GPIO interrupt type : rising edge                  */
    GPIO_INTR_NEGEDGE = 2,     /*!< GPIO interrupt type : falling edge                 */
    GPIO_INTR_ANYEDGE = 3,     /*!< GPIO interrupt type : both rising and falling edge */
    GPIO_INTR_LOW_LEVEL = 4,   /*!< GPIO interrupt type : input low level trigger      */
    GPIO_INTR_HIGH_LEVEL = 5,  /*!< GPIO interrupt type : input high level trigger     */
    GPIO_INTR_MAX,
} gpio_int_type_t;

ref：

GPIO & RTC GPIO - ESP32-C3 - — ESP-IDF 编程指南 latest 文档

esp-idf/gpio.h at ac315adc2c76309b8b9c82e166f03891ad2031bb · espressif/esp-idf · GitHub