迷你尺寸65mm*30mm香蕉派开发板Banana Pi BPI-M4 Zero 全志H618芯片4G ram+32G emmc

BPI-M4 Zero Introduction

Banana Pi BPI-M4 Zero is the successor model of M2 Zero. It has a huge improvement in performance. The SOC is upgraded to H618 and the CPU frequency is increased by 25%. The memory is upgraded to DDR4, the capacity is eightfold, and 32G eMMC is added. It supports 5G WiFi, and the USB interface has also been upgraded to type-C.

It has same form factor and 40-pin connector as the Raspberry Pi Zero W, and it can fit most of the RPI Zero W cases and accessories.

Key Features

• Allwinner H618, Quad-core ARM Cortex™-A53 processor

• ARM Mali G31 GPU

• 2.4G/5G WIFI & Bluetooth 5.0(K019 module is wifi5, K016 module is wifi4)

• 4G LPDDR4 RAM

• 32G eMMC flash memory

• 1x USB2.0 Type-C OTG, 5V power supply

• 1x USB2.0 Type-C

• 1x miniHDMI 2.0a

• 1x 24-pin FPC connector

  • 1x USB2.0 (in FPC connector)

  • 1x 100Mbps Ethernet (in FPC connector)

Hardware Spec

Hardware Specification of Banana pi BPI-M4 Zero
CPU	Allwinner H618, Quad-core ARM Cortex™-A53 processor, 64-bit, up to 1.5GHz
GPU	ARM Mali G31 GPU
Memory	4 GB LPDDR4
Storage	32G eMMC flash
SD card	MicroSD card slot, SDIO3.0
Wireless	2.4G/5G WiFi and Bluetooth 5.0
HDMI	1x miniHDMI 2.0a (up to 4K@60Hz with HDR10, CEC, DDC, SCDC), HDMI digital Audio output
USB	1x USB2.0 Type-C HOST, 1x USB2.0 Type-C OTG
40-pin header	28 pins GPIO and Power (+5V, +3.3V and GND)
	UART, SPI, TWI/I²C, PWM, PCM/I²S
24-pin FPC	0.5mm pitch FPC connector， 1x USB2.0, 1x IR, 1x 100Mbps Ethernet
	9 pins GPIO, UART,TWI/I²C, PWM, PCM/I²S
Buttons	Reset, FEL
LED	Power Status and Activity status
Power	5V@3A via USB Type-C
Size	65mm × 30mm