备忘：办公室电脑联想21.5寸连接树莓派config文件

办公室电脑为联想21.5寸显示器，带vga和DVI接口，使用DVI接口1080P设置时config文件

# For more options and information see

# http://www.raspberrypi.org/documentation/configuration/config-txt.md
# Some settings may impact device functionality. See link above for details


# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1


# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1


# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16


# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720


# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1


# uncomment to force a specific HDMI mode (this will force VGA)
hdmi_group=2
hdmi_mode=82
hdmi_ignore_edid=0xa5000080


# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2
#这里不知道为什么要禁止掉

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4


# uncomment for composite PAL
#sdtv_mode=2


#uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800


# Uncomment some or all of these to enable the optional hardware interfaces
#dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on


# Uncomment this to enable the lirc-rpi module
#dtoverlay=lirc-rpi