LTE CQI

CQI (Channel Quality Indication) report is an important element of LTE and has significant impact on the system performance. There are two types of CQI report in LTE: periodic and aperiodic. The periodic CQI report is carried by PUCCH. But if the UE needs to send UL data in the same subframe as the scheduled periodic CQI report, the periodic CQI report will use the PUSCH, together with UL data transmission. This is because a UE can't transmit on both PUCCH and PUSCH simultaneously. In this case, the periodic PUCCH resource will be idle. Since periodic CQI report brings in the "always on" signaling overhead, the report granularity is relatively rough. In order to get more detail CQI report, the eNB can trigger aperiodic CQI report when needed. The aperiodic CQI report is transmitted on PUSCH, together with UL data or alone.

The granularity of CQI report can be divided into three levels: wideband, UE selected subband, and higher layer configured subband. The wideband report provides one CQI value for the entire downlink system bandwidth. The UE selected subband CQI report divides the system bandwidth into multiple subbands, selects a set of preferred subbands (the best M subbands), then reports one CQI value for the wideband and one differential CQI value for the set (assume transmission only over the selected M subbands). The higher layer configured subband report provides the highest granularity. It divides the entire system bandwidth into multiple subbands, then reports one wideband CQI value and multiple differential CQI values, one for each subband.

If closed loop MIMO is used, PMI (Precoding Matrix Indicator) and RI (Rank Indication) are also reported. PMI indicates the codebook (pre-agreed parameters) the eNB should use for data transmission over multiple antennas based on the evaluation of received reference signal. RI indicates the number of transmission layers that the UE can distinguish. Spatial multiplexing can be supported only when RI>1. For spatial multiplexing, CQI is reported based on per codeword. The maximum number of codeword in LTE is two.

There are seven transmission modes in LTE, each one is corresponding to certain multiple antenna techniques. For each transmission mode, certain combination of CQI report is defined in the specs, based on periodic/aperiodic, wideband/UE selected subband/higher layer configured subband, No PMI/single PMI/multiple PMI. Since RI changes slower than CQI/PMI, it is reported with a longer interval on periodic report. It is reported together with CQI/PMI on aperiodic report since the resource on PUSCH is less limited.

 

 

周期性CQI，占用UE专用资源PUCCH，网络配置了以后，一直开着呢。

而有些事件的触发需要非周期cqi的上报，所有便有了dci0调度的pusch的非周期性cqi