videoInput样例

这是来源于videoInput.h中的一个例子：

        //create a videoInput object
	videoInput VI;
	
	//Prints out a list of available devices and returns num of devices found
	int numDevices = VI.listDevices();	
	
	int device1 = 0;  //this could be any deviceID that shows up in listDevices
	int device2 = 1;  //this could be any deviceID that shows up in listDevices
	
	//if you want to capture at a different frame rate (default is 30) 
	//specify it here, you are not guaranteed to get this fps though.
	//VI.setIdealFramerate(dev, 60);	
	
	//setup the first device - there are a number of options:
	
	VI.setupDevice(device1); 						  //setup the first device with the default settings
	//VI.setupDevice(device1, VI_COMPOSITE); 			  //or setup device with specific connection type
	//VI.setupDevice(device1, 320, 240);				  //or setup device with specified video size
	//VI.setupDevice(device1, 320, 240, VI_COMPOSITE);  //or setup device with video size and connection type

	//VI.setFormat(device1, VI_NTSC_M);					//if your card doesn't remember what format it should be
														//call this with the appropriate format listed above
														//NOTE: must be called after setupDevice!
	
	//optionally setup a second (or third, fourth ...) device - same options as above
	VI.setupDevice(device2); 						  

	//As requested width and height can not always be accomodated
	//make sure to check the size once the device is setup

	int width 	= VI.getWidth(device1);
	int height 	= VI.getHeight(device1);
	int size	= VI.getSize(device1);
	
	unsigned char * yourBuffer1 = new unsigned char[size];
	unsigned char * yourBuffer2 = new unsigned char[size];
	
	//to get the data from the device first check if the data is new
	if(VI.isFrameNew(device1)){
		VI.getPixels(device1, yourBuffer1, false, false);	//fills pixels as a BGR (for openCV) unsigned char array - no flipping
		VI.getPixels(device1, yourBuffer2, true, true); 	//fills pixels as a RGB (for openGL) unsigned char array - flipping!
	}
	
	//same applies to device2 etc
	
	//to get a settings dialog for the device
	VI.showSettingsWindow(device1);
	
	
	//Shut down devices properly
	VI.stopDevice(device1);
	VI.stopDevice(device2);