华为路由器的单臂路由配置

配置思路：

   1.配置终端设备

   2.配置网络设备

   3.测试与验证

R1配置:

<Huawei>undo terminal monitor 
<Huawei>system-view 
[Huawei]sysname R1
[R1]int g0/0/0.10
[R1-GigabitEthernet0/0/0.10]dot1q termination vid 10
[R1-GigabitEthernet0/0/0.10]ip add 192.168.10.254 24
[R1-GigabitEthernet0/0/0.10]arp broadcast enable 
[R1-GigabitEthernet0/0/0.10]int g0/0/0.20
[R1-GigabitEthernet0/0/0.20]dot1q termination vid 20
[R1-GigabitEthernet0/0/0.20]ip add 192.168.20.254 24
[R1-GigabitEthernet0/0/0.20]arp broadcast enable 
[R1-GigabitEthernet0/0/0.20]quit

SW1配置：

<Huawei>undo terminal monitor 
<Huawei>system-view 
[Huawei]sys SW1
[SW1]vlan batch 10 20
[SW1]int e0/0/1
[SW1-Ethernet0/0/1]port link-type trunk
[SW1-Ethernet0/0/1]port trunk allow-pass vlan all
[SW1-Ethernet0/0/1]int e0/0/2
[SW1-Ethernet0/0/2]port link-type access
[SW1-Ethernet0/0/2]port default vlan 10
[SW1-Ethernet0/0/2]int e0/0/3
[SW1-Ethernet0/0/3]port link-type access
[SW1-Ethernet0/0/3]port default vlan 20
[SW1-Ethernet0/0/3]