持续更新 风机相关知识

一。 风机装机容量相关知识

The Lake Benton II plant has 138 Zond Z50  turbines,each rated at 750 kilowatts (kW). The plant’s total wind-power generating capacity is 103.5 MW.Four 34.5-killivolt (kV) lines collect and feed the wind power into the local utility’s nearby115-kV transmission networkthrough a substation. Data-recording equipment was installed at  these four 34.5-kV interconnection points to collect read  power, reactive power, phase voltages, and wind speed. All data are recorded at a rate of 1 Hertz (Hz).  The data set from this wind power plant began in February 2000.

 每个风机容量：750kw

 风电场装机容量：103.5MW

 输出线路电压：34.5KV

 其他参考资料：

NREL has also contracted with a private firm to collect wind power output data from two other locations for this monitoring project. One is a large wind power plant located in northwestern Iowa near Storm Lake, which has 262 Zond Z50 turbines. The total installed wind power capacity is 196.5 MW. The output from 151 turbines (113.25 MW) is monitored under the contract. In addition to real and reactive power, phase voltages, and wind speed data at 1 Hz, wind direction information is also recorded. Data from Storm Lake have been available since January 2001. The other location is a substation called Buffalo Ridge, located in southwestern Minnesota. There are several wind power plants of varying size in this area. Approximately 220 MW of wind generating capacity is connected to the Buffalo Ridge substation, where data monitoring is taking place. Most of the wind turbines in this area are Zond Z50 turbines. There are also a small number of Micon 750-kW and Vestas 660- kW turbines. Data from this site began in mid-February 2001. The contract requires at least two years data from both sites.