capture network traffic on windows ce

When developing network applications, it's always necessary to capture network traffic. Windows ce has built-in sniffer tool, netlog for this purpose. It captures network traffics to a file that can be examined with wireshark or network monitor.
To enable it, we need to select NDIS Packet Capturing DLL and NDIS User-mode I/O Protocol Driver in visual studio, as shown below.

Then, we can capture network traffic with following commands.

1. set capture file lacation:

netlogctl file "/Storage Card/net"

2. start capture

netlogctl start

3. perform network activities
4. stop capture

netlogctl stop

5. copy /Storage Card/net.cap[i].cap to computer and open with wireshark



NetLogctl usage:
netlogctl start - start the loggging.
netlogctl load - start the loggging.
netlogctl stop - stops the loggging.
netlogctl unload - causes networking to unload the netlog component. (may destabilize system)
netlogctl pkt_size  XX - sets maximum packet size captured.
netlogctl cap_size  XX - sets maximum  size of half capture file.
netlogctl file  XXX - sets the name of the file to log.
netlogctl usb  XXX - 1 => log usb , 0 => stop logging usb.
netlogctl state  - print state.
netlogctl trace  - print trace message state for all modules.
netlogctl trace <module> - print trace message state for specified module.
netlogctl trace <module> <filter> - set trace message state for specified module.