GSV6505 1 In to 4 Out HDMI 2.1 Splitter

General Description

Gscoolink GSV6505 is a high-performance, low-power 1 In to 4 Out HDMI 2.1 to HDMI 2.1 splitter. By integrating enhanced microcontroller based on RISC-V, GSV6505 has created a cost-effective solution that provides time-to-market advantages. GSV6505’s HDMI Receiver and HDMI Transmitter supports up to 48Gbps (FRL, 12G/4Lane). The superior architecture of GSV6505 provides economical smaller footprint solutions using QFN96, targeting applications of Consumer and ProAV.

HDMI Receiver Features 
 Compliant with HDMI 2.1, HDMI 2.0b, HDMI 1.4b
 Compliant with HDCP 2.2/2.3 and HDCP 1.4 in repeater/receiver mode
 Data rate up to 48Gbps (FRL 12Gbps/4 Lane)
 Programmable Adaptive Equalization 
 Support High Dynamic Range (HDR) and Dynamic/Static Metadata
 Support Variable Refresh Rate (VRR), FreeSync, G-Sync
 Support ALLM
 Support Forward Error Correction (FEC)
 Support DSC pass-through for compressed input timing
 Embedded arbitrary EDID (up to 512 bytes)
 5V tolerance on DDC/HPD pins

HDMI Transmitter Features 
 Compliant with HDMI 2.1a, HDMI 2.0b, HDMI 1.4b
 Compliant with HDCP 2.2/2.3 and HDCP 1.4
 Data rate up to 48Gbps (FRL 12Gbps/4 Lane)
 Programmable Voltage Swing, Slew-Rate andPre-emphasis
 Support AC-coupling on TMDS input/output
 Support Color Space Converter in TMDS mode
 Support HDR (HDR10/HDR10+/Dolby Vision/HLG)
 Support Variable Refresh Rate (VRR), FreeSync, G-Sync
 Support ALLM
 Support DSC encoded stream pass-through from HDMI/DP input
 Hardware CEC Engine for Low Level protocol decoding
 5V tolerance on DDC/HPD/CEC pins

Pixel Processor Features 
 HDR to SDR conversion for HDR10, HDR10+, HLG and Low Latency DolbyVision
 Color Space conversion
 YCbCr 444-420 timing conversion
 Downscaler with selectable 2/3/4/8/16/32 ratio
 Deinterlacer for interlaced timingAudio Input/Output Features 
 I2S and SPDIF Audio Extraction from HDMI Rx
 I2S/SPDIF Audio Insertion to HDMI Tx
 SPDIF/I2S/HBR/DSD/TDM Format Supported for

Audio Extraction and Insertion
 SPDIF to I2S Conversion using single TTL bus in Bi-direction

System Features 
 Optional External MCU (via I2C)/ Internal MCU mode for chip control
 Embedded MCU and External Flash
 External pins of Flash QSPI interface
 External 25MHz Crystal required
 Available Pins for UART/Timer/GPIO
 Temperature Sensor Monitoring Circuit