S3C2440A IIC驱动(AT24c04)

int f_nGetACK;
/*********************************************************************************
* name:  iic_test
* func:  test iic
* para:  none
* ret:  none
* modify:
* comment:  
*********************************************************************************/
void iic_test(void)
{
    char szData[16] = "liuzhiping";
    unsigned int  i;
    
    Uart_Printf("\n IIC Protocol Test Example, using AT24C04...\n");
    Uart_Printf(" Write char 0-f into AT24C04\n");
   
    f_nGetACK = 0;
   
    // Enable interrupt
    rINTMOD  = 0x0;
    ClearPending(BIT_IIC);
    rINTMSK &= ~BIT_IIC;
    pISR_IIC = (unsigned)iic_int_24c04;
   
    // Initialize iic
    rIICADD = 0x10;            // S3C2410X slave address
    rIICCON = 0xaf;            // Enable ACK, interrupt, SET IICCLK=MCLK/16
    rIICSTAT = 0x10;           // Enable TX/RX

    // Write 0 - 16 to 24C04
    for(i=0; i<16; i++)
    {
        iic_write_24c040(0xa0, i, szData[i]);
        Uart_Printf(" %d", szData[i]);
        Delay(10);
    }

    // Clear array
    for(i=0; i<16; i++)
        szData[i]=0;

    // Read 16 byte from 24C04
    for(i=0; i<16; i++)
        iic_read_24c040(0xa0, i, &(szData[i]));
   
    // Printf read data
    Uart_Printf(" \nRead 16 bytes from AT24C04\n");
    for(i=0; i<16; i++)
    {
        Uart_Printf(" %c ", szData[i]);
    }

    rINTMSK |= BIT_IIC;
    Uart_Printf("\n end.\n");
}
/*****************************************************************************