Mbed OS 文档翻译 之 参考（API（驱动（DigitalOut）））

DigitalOut

使用 DigitalOut 接口通过将引脚设置为逻辑电平 0 或 1 来配置和控制数字输出引脚。

DigitalOut 类参考

mbed::DigitalOut 类参考

公共成员函数
	DigitalOut (PinName pin)
	DigitalOut (PinName pin, int value)
void	write (int value)
int	read ()
int	is_connected ()
DigitalOut &	operator= (int value)
DigitalOut &	operator= (DigitalOut &rhs)
	operator int ()

受保护的属性
gpio_t	gpio

DigitalOut hello, world

main.cpp                                                                                                                                             导入到 Mbed IDE

/* mbed Example Program
 * Copyright (c) 2006-2014 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */
#include "mbed.h"

DigitalOut myled(LED1);

int main()
{
    // check that myled object is initialized and connected to a pin
    if(myled.is_connected()) {
        printf("myled is initialized and connected!\n\r");
    }

    // Blink LED
    while(1) {
        myled = 1;          // set LED1 pin to high
        printf("myled = %d \n\r", (uint8_t)myled );
        wait(0.5);

        myled.write(0);     // set LED1 pin to low
        printf("myled = %d \n\r",myled.read() );
        wait(0.5);
    }
}