Mbed OS 文档翻译 之 参考（API（驱动（DigitalInOut）））

DigitalInOut

使用 DigitalInOut 接口作为双向数字引脚：

• 设置为 input() 时，读取数字引脚的值。
• 设置为 output() 时写入值。

您可以将任何编号的 Arm Mbed 引脚用作 DigitalInOut。

       注意: 某些平台在输入和输出之间切换时会有时间延迟。

DigitalInOut 类参考

mbed::DigitalInOut 类参考

公共成员函数
	DigitalInOut (PinName pin)
	DigitalInOut (PinName pin, PinDirection direction, PinMode mode, int value)
void	write (int value)
int	read ()
void	output ()
void	input ()
void	mode (PinMode pull)
int	is_connected ()
DigitalInOut &	operator= (int value)
DigitalInOut &	operator= (DigitalInOut &rhs)
	operator int ()

受保护的属性
gpio_t	gpio

DigitalInOut hello, world

main.cpp                                                                                                                                             导入到 Mbed IDE

/* mbed Example Program
 * Copyright (c) 2006-2014 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */
#include "mbed.h"

DigitalInOut mypin(LED1);

int main()
{
    // check that mypin object is initialized and connected to a pin
    if(mypin.is_connected()) {
        printf("mypin is initialized and connected!\n\r");
    }

    // Optional: set mode as PullUp/PullDown/PullNone/OpenDrain
    mypin.mode(PullNone);

    while(1) {
        // write to pin as output
        mypin.output();
        mypin = !mypin; // toggle output
        wait(0.5);

        // read from pin as input
        mypin.input();
        printf("mypin.read() = %d \n\r",mypin.read());
        wait(0.5);
    }
}