NVIDIA Jetson TX2 通过JetPack 3.1刷机后不能启动连网问题解决

    Mark一个Jetson TX2刷机后不能启动的问题。

    问题的现象是Jetson TX2 通过JetPack 3.1更新固件成功，但是reboot后没有显示，也没有eth0的网络连接，主机控制台卡在“Determing the IP address of target...”，如图1所示，手动复位还是这样，以至于主机的JetPack 3.1不能完成后续的步骤。

    问题的原因是Jetson TX2连接显示器的HDMI-VGA适配器不被启动时的linux识别，导致卡在检测显示适配器这一步，如下所示，更换HDMI-DVI或者带HDIM接口的显示器后就可以成功启动看到图形界面。

[    0.503413] Unsupported HDMI VIC 15, ignoring
[    0.503414] Unsupported HDMI VIC 140, ignoring
[    0.503415] Unsupported HDMI VIC 10, ignoring
[    0.503417] Unsupported HDMI VIC 208, ignoring
[    0.503418] Unsupported HDMI VIC 138, ignoring
[    0.503419] Unsupported HDMI VIC 32, ignoring
[    0.503426] V_REF_TO_SYNC >= 1; H_REF_TO_SYNC < 0
[    0.503429] tegradc 15210000.nvdisplay: Display timing doesn't meet restrictions.
[    0.503431] PD DISP2 index4 DOWN
[    0.503595] PD DISP1 index3 DOWN
[    0.503739] PD DISP0 index2 DOWN
[    0.505718] tegradc 15210000.nvdisplay: probed

 图1 Determing the IP address of target...

转载于:https://www.cnblogs.com/ailexy/p/7266972.html