树莓派配置文件

坑点

按理说只要更改

hdmi_group=2 —>1:CEA 2:DMT
hdmi_mode=4 —>从模式列表中选取一种显示模式

就可以切换显示分辨率了，可是怎么改都没啥用。貌似不起任何作用！
当hdmi_safe设置为1时，hdmi_group默认为1，hdmi_mode为1，后面你怎么改hdmi_group和hdmi_mode都不起作用了！！！
当disable_overscan=1时，overscan_top、overscan_botom、overscan_left、overscan_right几个参数不起作用！

## hdmi_safe
##     Use "safe mode" settings to try to boot with maximum hdmi compatibility.
##
##     Value    Description
##     -------------------------------------------------------------------------
##     0        Disabled (Default)
##     1        Enabled (this does: hdmi_force_hotplug=1, config_hdmi_boost=4,
##                                  hdmi_group=1, hdmi_mode=1,
##                                  disable_overscan=0)
##
#hdmi_safe=1

最终文件

pi@raspberrypi:/boot$ vi config.txt 
#hdmi_edid_file=1

# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=-30
#overscan_right=-30
#overscan_top=-30
#overscan_bottom=-30

# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720

# uncomment if hdmi display is not detected and composite is being output
hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
hdmi_group=2
hdmi_mode=32

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

#uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800