ksz9031 mmd读取不了_Re: 使用KSZ9031 IC，Ethernet 无法使用1000M Lan

Translated by Google:

Use KSZ9031 IC, Ethernet can not use the 1000M Lan

We are using KSZ9031 scenario, if set to 10M / 100M no problem, but if set to 1000M, you can not connect.

Router supports the 1000M.

-------------------------------------------------

Hi Guo

suggest to check Table 62. RGMII Signal Switching Specifications IMX6DQCEC

and configure KSZ9031 registers if necessary, like

MMD Address 2h  Register 5h - RGMII RX Data Pad Skew

MMD Address 2h  Register 6h - RGMII TX Data Pad Skew

MMD Address 2h  Register 8h - RGMII Clock Pad Skew

Note, for i.MX6 ENET there is no control on-chip to adjust the delay between

these signals. A delay would need to be implemented at the board level.

Best regards

igor

-----------------------------------------------------------------------------------------------------------------------

Note: If this post answers your question, please click the Correct Answer button. Thank you!

-----------------------------------------------------------------------------------------------------------------------