基于matlab计算aom衍射效率,傅里叶望远镜大气湍流模拟实验

最新推荐文章于 2024-07-08 03:18:38 发布

weixin_39793434

最新推荐文章于 2024-07-08 03:18:38 发布

阅读量1.1k

点赞数

文章标签：基于matlab计算aom衍射效率

该实验基于matlab模拟了大气湍流对傅里叶望远镜系统中光强闪烁和相位抖动的影响。通过控制射频驱动器的输出功率和瞬时频率，分别模拟了光强和相位的随机变化。实验结果显示，光强闪烁对单束光成像影响不大，但相位抖动严重影响三束光的成像质量。因此，消除光强和相位抖动是提高傅里叶望远镜图像重建算法的关键。

摘要由CSDN通过智能技术生成

引用本文

曾志红, 罗秀娟, 王保峰, 夏爱利, 程志远, 司庆丹. 傅里叶望远镜大气湍流模拟实验.光子学报, 2014,43(6): 601002

ZENG Zhi-hong, LUO Xiu-juan, WANG Bao-feng, XIA Ai-li, CHENG Zhi-yuan, SI Qing-dan. Laboratory Simulation of Atmosphere Turbulence for Fourier Telescopy. ACTA PHOTONICA SINICA, 2014,43(6): 601002

DOI:10.3788/gzxb2014430 .0601002

Permissions

中国科学院西安光学精密机械研究所保留一切权利

傅里叶望远镜大气湍流模拟实验

曾志红1,2, 罗秀娟1, 王保峰1,2, 夏爱利1, 程志远1,2, 司庆丹1,2

1 中国科学院西安光学精密机械研究所,西安 710119

2 中国科学院大学,北京 100049

导师(通讯作者):罗秀娟(1964-),女,研究员,主要研究方向为高分辨率光学成像技术和光电跟踪测量.Email:xj_luo@opt.ac.cn

收稿日期:2014-01-17

基金:总装备部重大研究项目(No.7131130)资助

摘要

傅里叶望远术是一种能对深空暗弱目标进行高分辨率成像的技术.为了验证大气湍流对傅里叶望远镜系统的影响,进行了实验室环境下大气湍流模拟实验研究.在三束光傅里叶望远镜实验系统上,通过控制射频驱动器的输出功率来模拟光强抖动,改变射频驱动器的瞬时频率来模拟相位抖动.给出了实验理论依据,推导了湍流强度与实验变量的关系.实验在弱湍流闪烁和相位抖动两种情况下,分别给单束光和三束光加随机扰动并计算其Strehl比.结果表明,只在单束光上加扰动时重建图像影响不大;在三束光上加扰动时,弱湍流光强抖动对傅里叶望远镜系统的成像效果影响具有较大的随机性,而相位抖动会严重影响系统成像质量.因此,消除光强抖动和相位抖动影响是图像重建算法改进应该考虑的一个关键因素.

关键词:

傅里叶望远术; 大气湍流; 湍流模拟; 闪烁; 相位抖动; 图像重构; 成像系统

中图分类号:TH743

文献标志码:A

文章编号:1004-4213(2014)0-0601002-7

Laboratory Simulation of Atmosphere Turbulence for Fourier Telescopy

ZENG Zhi-hong1,2, LUO Xiu-juan1, WANG Bao-feng1,2, XIA Ai-li1, CHENG Zhi-yuan1,2, SI Qing-dan1,2

1 Xi'an Institute of Optics and Precision Mechanics of Chinese Academy of Sciences (CAS),Xi'an 710119, China

2 Graduate University of CAS, Beijing 100049, China

Abstract

Fourier telescopy is a sort of high-resolution imaging technology for deep space object which is very small and dim. To verify the atmosphere turbulence net effect on Fourier telescope, the experimental demonstrations of atmosphere turbulence simulation were performed in a lab. Based on the laboratory system of three-beam Fourier telescope, the scintillation and the phase jitter were simulated by changing the radio-frequency driver output power and the instantaneous frequency, respectively. The detail of the experimental principle was presented, and the relation between the turbulent intensity and experimental variable was built. For different cases with random scintillation and phase jitter in weak turbulence, the experiments were conducted for single beam and three beams, and all the results’ Strehl ratio were calculated. The experimental results indicate that, with single beam holding turbulence, there are no obvious change for all the reconstructed image; with three beams adding turbulence, the image quality of the Fourier telescope system is few influenced by weak scintillation, but is severe affected by phase jitter. As indicated, removing the phase and light intensity jitter effect is a key point of improving the image reconstruction arithmetic.

Keyword:

Fourier telescopy; Atmosphere turbulence; Turbulence simulation; Scintillation; Phase jitter; Image reconstruction; Imaging systems