静态路由实验报告

一.实验拓扑图（图一）

二.静态路由实验的实验要求：

1.除了R5的环回地址固定5.5.5.0/24，其他网段基于192.168.1.0/24进行合理划分；
2.R1-R4每个路由器存在两个环回接口，模拟PC，地址也在192.168.1.0/24网络内；
3.R1-R4不能直接编写到达5.5.5.0/24的静态路由，但依然可以访问；
4.全网可达，尽量减少每台路由器路由条目数量，避免环路；
5.R4与R5间，正常1000M链路通信，故障时自动改为100M；

三.静态路由实验的实验思路

1.划分IP地址，给每台设备配置上合适的IP地址。（如上图一所示）

2.编写除了到达5.5.5.0/24之外的到达其他网段的静态路由IP地址。

3.配置缺省路由，实现5.5.5.0/24互通，实现全网通并对其进行测试是否完成互通。

4.防环，做黑洞路由配置。

5.做备份，通过改变路由条目优先级实现。

6.测试，观察1000Mb/s链路故障时，数据能否走100Mb/s链路。

四.实验步骤

1、配置IP地址

[R1]int g0/0/0

[R1-GigabitEthernet0/0/0]ip add 192.168.1.1 30

[R1-GigabitEthernet0/0/0]int g0/0/1

[R1-GigabitEthernet0/0/1]ip add 192.168.1.5 30

[R1]int-l0

[R1-LoopBack0]ip add 192.168.1.33 28

[R1-LoopBack0]int l1

[R1-LoopBack1]ip add 192.168.1.49 28

[R2]int g0/0/0

[R2-GigabitEthernet0/0/0]ip add 192.168.1.2 30

[R2-GigabitEthernet0/0/0]int g0/0/1

[R2-GigabitEthernet0/0/1]ip add 192.168.1.9 30.

[R2]int l0
[R2-LoopBack0]ip add-192.168.1.65 28

[R2-LoopBack0]int l1

[R2-LoopBack1]ip add 192.168.1.81 28

[R3]int g0/0/0

[R3-GigabitEthernet0/0/0]ip add 192.168.1.13 30

[R3-GigabitEthernet0/0/0]int g0/0/1

[R3-GigabitEthernet0/0/1]ip add 192.168.1.6 30

[R3]int l0

[R3-LoopBack0]ip add192.168.1.97 28 

[R3-LoopBack0]int l1

[R3-LoopBackl]ip add 192.168.1.113 28

[R4]int g0/0/0

[R4-GigabitEthernet0/0/0]ip add 192.168.1.10 30

[R4-GigabitEthernet0/0/0]int g0/0/1

[R4-GigabitEthernet0/0/1]ip add 192.168.1.14 30

[R4]int g0/0/2

[R4-GigabitEthernet0/0/2]ip add 192.168.1.17 30

[R4-GigabitEthernet0/0/2]int g4/0/0

[R4-GigabitEthernet4/0/0]ip add 192.168.1.21 30

[R4]int l0

[R4-LoopBack0]ip add 192.168.1.129 28

[R4-LoopBack0]int l1

[R4-LoopBack1]ip add 192.168.1.145 28

[R5]int g0/0/0

[R5-GigabitEthernet0/0/0]ip add 192.168.1.18 30

[R5]int g0/0/1

[R5-GigabitEthernet0/0/0]ip add 192.168.1.22 30 

[R5]int 10

[R5-LoopBack0]ip add 5.5.5.5 24

2、配置路由，除5.5.5.0/24外，实现其他网段可达。

[R1]ip route-static 192.168.1.64 27 192.168.1.2

[R1]ip route-static 192.168.1.8 30 192.168.1.2

[R1]ip route-static 192.168.1.128 27 192.168.1.2

[R1]ip route-static 192.168.1.128 27 192.168.1.6

[R1]ip route-static 192.168.1.16 30 192.168.1.2
[R1]ip route-static 192.168.1.16 30 192.168.1.6

[R1]ip route-static 192.168.1.12 30 192.168.1.6

[R1]ip route-static 192.168.1.96 27 192.168.1.6

[R1]ip route-static 192.168.1.20 30 192.168.1.2

[R1]ip route-static 192.168.1.20 30 192.168.1.6

[R2]ip route-static 192.168.1.4 255.255.255.252 192.168.1.1

[R2]ip route-static 192.168.1.12 255.255.255.252 192.168.1.10

[R2]ip route-static 192.168.1.16 255.255.255.252 192.168.1.10

[R2]ip route-static 192.168.1.20 255.255.255.252 192.168.1.10

[R2]ip route-static 192.168.1.96 255.255.255.224 192.168.1.10

[R2]ip route-static 192.168.1.96 255.255.255.224 192.168.1.1

[R2]ip route-static 192.168.1.128 255.255.255.224 192.168.1.10

[R2]ip route-static 192.168.1.32 27 192.168.1.1

[R3]ip route-static 192.168.1.0 255.255.255.252 192.168.1.5

[R3]ip route-static 192.168.1.8 255.255.255.252 192 168.1.14

[R3]ip route-static 192.168.1.16 255.255.255.252 192.168.1.14

[R3]ip route-static 192.168.1.20 255.255.255.252 192.168.1.14

[R3]ip route-static 192.168.1.32 255.255.255.224 192.168.1.5

[R3]ip route-static 192.168.1.64 255.255.255.224 192.168.1.5

[R3]ip route-static 192.168.1.64:255.255.255.252:192.168.1.14

[R3]ip route-static 192.168.1.128 255.255.255.224 192.168.1.14

[R4]ip route-static 192.168.1.64 27 192.168.1.9

[R4]ip route-static 192.168.1.0 30 192.168.1.9.

[R4]ip route-static 192.168.1.32 27 192.168.1.9

[R4]ip route-static 192.168.1.96 27 192.168.1.13

[R4]ip route-static 192.168.1.4 30 192.168.1.13

[R4]ip route-static 192.168.1.32 27 192.168.1.13

[R5]ip route-static 192.168.1.32 27 192.168.1.17

[R5]ip route-static 192.168.1.64 27 192.168.1.17

[R5]ip route-static 192.168.1.96 27 192.168.1.17

[R5]ip route-static 192.168.1.128 27 192.168.1.17

[R5]ip route-static 192.168.1.0 30 192.168.1.17

[R5]ip route-static 192.168.1.8 30 192.168.1.17

[R5]ip route-static 192.168.1.4 30 192.168.1.17

[R5]ip route-static 192.168.1.12 30 192.168.1.17

[R5]ip route-static 192.168.1.0 255.255.255.252 192.168.1.21

[R5]ip route-static 192.168.1.4 255.255.255.252 192.168.1.21

[R5jip route-static 192.168.1.8 255.255.255.252 192.168.1.21

[R5]ip route-static 192.168.1.12 255:255.255.252 192.168.1.21

[R5]ip route-static 192.168.1.32 255.255.255.224 192.168.1.21

[R5]ip route-static 192.168.1.64 255.255.255.224 192.168.1.21

[R5]ip route-static 192.168.1.96 255.255.255.224 192.168.1.21

[R5]ip route-static 192.168.1.128 255.255.255.224 192.168.1.21

测试IP是否通路：

3、配置缺省路由，实现 5.5.5.0/24 互通。

[R1]ip route-static 0.0.0.0 0 192.168.1.2

[R1]ip route-static 0.0.0.0 0 192 168.1.6

[R2]ip route-static 0.0.0.0 0 192.168.1.10

[R3]ip route-static 0.0.0.0 0 192.168.1.14.

[R4]ip route-static 0.0.0.0 0 192.168.1.18

[R4]ip route-static 0.0.0.0·0-192.168.1.22

4、防环，做黑洞路由配置。

[R1]ip route-static 192.168.1.32 27 NULL 0

[R2]ip route-static 192.168.1.64 27 NULL 0

[R3]ip route-static 192.168.1.96 27 NULL 0

[R4]ip route-static 192.168.1.128 27 NULL 0

5、做备份

[R4]iproute-static 0.0.0.0 0 192.168.1.22 preference.61

[R5]ip route-static 192.168.1.0 255.255.255.252 192.168.1.21 preference61
[R5]ip route-static 192.168.1.4 255.255.255.252 192.168.1.21 preference61

[R5]ip route-static 192.168.1.8 255.255.255.252 192.168.1.21 preference61
[R5]ip route-static  192.168.1.12 255.255.255.252 192.168.1.21 preference 61

[R5]ip route static 192.168.1.32 255.255.255.224 192.168.1.21 preference61

[R5]ip route static 192.168.1.64 255.255.255.224 192.168.1.21 preference61

[R5]ip route-static 192.168.1.96 255.255.255.224 192.168.1.21 preference61
[R5]ip route-static 192.168.1.128 255.255.255.224 192.168.1.21 preference.61

6、测试: