H3C IRF堆叠实验1

---

一、拓扑图

二、组网需求

将SW1 SW2 建立堆叠

三、配置步骤

1.更改板卡层数

1. 将SW2板卡层数从1改为2

[SW2]irf member 1 renumber 2

2. 保存SW2并重启

<SW2>save f
<SW2>reboot

检查：在SW2上查看，板卡层数为2

2.配置IRF

1. 关闭SW1、SW2上的互连端口

[SW1]interface range Ten-GigabitEthernet 1/0/49 Ten-GigabitEthernet 1/0/50
[SW1-if-range]shutdown

[SW2]interface range Ten-GigabitEthernet 2/0/49 Ten-GigabitEthernet 2/0/50
[SW2-if-range]shutdown

2. 将SW1、SW2上的互连端口，放出 irf 组

[SW1]irf-port 1/1
[SW1-irf-port1/1]port group interface Ten-GigabitEthernet 1/0/49
[SW1-irf-port1/1]port group interface Ten-GigabitEthernet 1/0/50

[SW2]irf-port 2/2
[SW2-irf-port2/2]port group interface Ten-GigabitEthernet 2/0/49
[SW2-irf-port2/2]port group interface Ten-GigabitEthernet 2/0/50

3. 开启SW1、SW2上的互连端口,并保存

[SW1]interface range Ten-GigabitEthernet 1/0/49 Ten-GigabitEthernet 1/0/50
[SW1-if-range]undo shutdown
[SW1-if-range]save

[SW2]interface range Ten-GigabitEthernet 2/0/49 Ten-GigabitEthernet 2/0/50
[SW2-if-range]undo shutdown
[SW2-if-range]save

5. 激活 irf

[SW1]irf-port-configuration active

[SW2]irf-port-configuration active

6. 配置完成，备用 irf 重启后同步

---

总结