MTK gps配置.txt

1. 1. 查看原理图：

2. GPS xLNA

3. --GPIO_GPS_LNA_EN // 据此查到对应GPIO79(AL27)

4.  

5. 2. 修改dws：

6.  

7. 3. 修改dts：

8. /* CONSYS GPIO standardization */

9. &pio {

10. consys_pins_default: default {

11.  

12. };

13.  

14. gpslna_pins_init: gpslna@0 {

15.  

16. pins_cmd_dat {

17. pins = <PINMUX_GPIO79__FUNC_GPIO79>;

18. slew-rate = <0>;

19. bias-disable;

20. output-low;

21. };

22. };

23.  

24. gpslna_pins_oh: gpslna@1 {

25.  

26. pins_cmd_dat {

27. pins = <PINMUX_GPIO79__FUNC_GPIO79>;

28. slew-rate = <1>;

29. output-high;

30. };

31. };

32.  

33. gpslna_pins_ol: gpslna@2 {

34.  

35. pins_cmd_dat {

36. pins = <PINMUX_GPIO79__FUNC_GPIO79>;

37. slew-rate = <1>;

38. output-low;

39. };

40. };

41.  

42. };

43.  

44. &consys {

45. pinctrl-names = "default", "gps_lna_state_init", "gps_lna_state_oh", "gps_lna_state_ol";

46. pinctrl-0 = <&consys_pins_default>;

47. pinctrl-1 = <&gpslna_pins_init>;

48. pinctrl-2 = <&gpslna_pins_oh>;

49. pinctrl-3 = <&gpslna_pins_ol>;

50. status = "okay";

51.  

52. };

53.  
54.  

55. 二、由省gps晶体，改为不省gps晶体

56. 1. 修改alps\device\mediatek\mt6580\WMT_SOC.cfg

57. - co_clock_flag=1 // 默认为省晶体

58. + co_clock_flag=0

59.  

60. 2. 修改alps\vendor\mediatek\proprietary\custom\k80hd_bsp_fwv_512m\cgen\cfgdefault\CFG_GPS_Default.h

61. ap_nvram_gps_config_struct stGPSConfigDefault =

62. {

63. /* if chip detector say it's not 3332 use /dev/stpgps,else use /ttyMT1 */

64. {'/','d','e','v','/','s','t','p','g','p','s',0x0,0x0,0x0,0x0,0x0,0x0,0x0,0x0,0x0},

65. /* 0:s/w, 1:none, 2:h/w */

66. 1,

67.  

68. /* 26MHz */

69. 26000000,

70. /* default is 0ppm, by chip definetion. 6620 is 500, else 2000 */

71. 0,

72. /* 0:16.368MHz TCXO */

73. - 0xFE, // 默认为0xFF，省晶体要配为0xFE

74. + 0xFF, // 默认为0xFF，不省晶体要配为0xFF

75.  

76. 3. 更改modem配置-重新配modem

77.