MTK驱动（84）---GPS 配置

1. 1. 查看原理图：
2. GPS xLNA
3. --GPIO_GPS_LNA_EN // 据此查到对应GPIO79(AL27)
5. 2. 修改dws：
7. 3. 修改dts：
8. /* CONSYS GPIO standardization */
9. &pio {
10. consys_pins_default: default {
12. };
14. gpslna_pins_init: gpslna@0 {
16. pins_cmd_dat {
17. pins = <PINMUX_GPIO79__FUNC_GPIO79>;
18. slew-rate = <0>;
19. bias-disable;
20. output-low;
21. };
22. };
24. gpslna_pins_oh: gpslna@1 {
26. pins_cmd_dat {
27. pins = <PINMUX_GPIO79__FUNC_GPIO79>;
28. slew-rate = <1>;
29. output-high;
30. };
31. };
33. gpslna_pins_ol: gpslna@2 {
35. pins_cmd_dat {
36. pins = <PINMUX_GPIO79__FUNC_GPIO79>;
37. slew-rate = <1>;
38. output-low;
39. };
40. };
42. };
44. &consys {
45. pinctrl-names = "default", "gps_lna_state_init", "gps_lna_state_oh", "gps_lna_state_ol";
46. pinctrl-0 = <&consys_pins_default>;
47. pinctrl-1 = <&gpslna_pins_init>;
48. pinctrl-2 = <&gpslna_pins_oh>;
49. pinctrl-3 = <&gpslna_pins_ol>;
50. status = "okay";
52. };
55. 二、由省gps晶体，改为不省gps晶体
56. 1. 修改alps\device\mediatek\mt6580\WMT_SOC.cfg
57. - co_clock_flag=1 // 默认为省晶体
58. + co_clock_flag=0
60. 2. 修改alps\vendor\mediatek\proprietary\custom\k80hd_bsp_fwv_512m\cgen\cfgdefault\CFG_GPS_Default.h
61. ap_nvram_gps_config_struct stGPSConfigDefault =
62. {
63. /* if chip detector say it's not 3332 use /dev/stpgps,else use /ttyMT1 */
64. {'/','d','e','v','/','s','t','p','g','p','s',0x0,0x0,0x0,0x0,0x0,0x0,0x0,0x0,0x0},
65. /* 0:s/w, 1:none, 2:h/w */
66. 1,
68. /* 26MHz */
69. 26000000,
70. /* default is 0ppm, by chip definetion. 6620 is 500, else 2000 */
71. 0,
72. /* 0:16.368MHz TCXO */
73. - 0xFE, // 默认为0xFF，省晶体要配为0xFE
74. + 0xFF, // 默认为0xFF，不省晶体要配为0xFF
76. 3. 更改modem配置-重新配modem