arduino应用开发：第十四章代码及练习答案

代码编号：BT_softwareSerial_0

[code]
#include <SoftwareSerial.h>
SoftwareSerial mySerial(11, 8); // RX, TX
int cnt = 0;

void setup() {
  // put your setup code here, to run once:
  Serial.begin(19200);
  mySerial.begin(9600);
}

void loop() {
  // put your main code here, to run repeatedly:
  mySerial.print("Message:");
  delay(1000);
  mySerial.println(cnt);
  delay(5000);

}
[/code]

=========================================================================

代码编号: BT_softwareSerial_1

[code]
#include <SoftwareSerial.h>
SoftwareSerial mySerial(11, 8); // RX, TX
int cnt = 0;

void setup() {
  // put your setup code here, to run once:
  Serial.begin(19200);
  mySerial.begin(9600);
}

void loop() {
  // 虚拟串口向手机发送数据
  mySerial.print("Message:");
  delay(1000);
  mySerial.println(cnt);
  delay(5000);

  if(mySerial.available() ) //条件满足说明虚拟串口有未读数据
  {
      unsigned char inChar = mySerial.read(); 
      Serial.write(inChar);
      cnt++;   //收到一个字符，计数值加一
  }
}
[/code]

=======================================================================

代码编号：BT_AT

#include <SoftwareSerial.h>
SoftwareSerial mySerial(11, 8); // RX, TX
int cnt = 0;

void setup() {
  // put your setup code here, to run once:
  Serial.begin(19200);
  mySerial.begin(9600);
}

void loop() {
  // 虚拟串口向手机发送数据
  mySerial.println("AT");   //可以在这指令后面继续添加你需要的AT指令
  
  if(mySerial.available() ) //条件满足说明虚拟串口有未读数据
  {
      unsigned char inChar = mySerial.read(); 
      Serial.write(inChar);      
  }
  delay(1000);
}