Jlink命令

Jlink命令

J-Link>?

Available commands are:
----------------------
f          Firmware info
h          halt
IsHalted   Returns the current CPU state (halted / running)
WaitHalt   Waits until the CPU is halted or the given timeout is exceeded.
             Syntax: WaitHalt <TimeoutMs>  Default timeout is 1000 ms
g          go
Sleep      Waits the given time (in milliseconds). Syntax: Sleep <delay>
s          Single step the target chip
             Syntax: s [<NumSteps (dec)>]
st         Show hardware status
hwinfo     Show hardware info
mem        Read memory. Syntax: mem  [<Zone>:]<Addr>, <NumBytes> (hex)
mem8       Read  8-bit items. Syntax: mem8  [<Zone>:]<Addr>, <NumBytes> (hex)
mem16      Read 16-bit items. Syntax: mem16 [<Zone>:]<Addr>, <NumItems> (hex)
mem32      Read 32-bit items. Syntax: mem32 [<Zone>:]<Addr>, <NumItems> (hex)
w1         Write  8-bit items. Syntax: w1 [<Zone>:]<Addr>, <Data> (hex)
w2         Write 16-bit items. Syntax: w2 [<Zone>:]<Addr>, <Data> (hex)
w4         Write 32-bit items. Syntax: w4 [<Zone>:]<Addr>, <Data> (hex)
erase      Erase internal flash or flash range of selected device. Syntax: erase [<SAddr>, <EAddr>]
wm         Write test words. Syntax: wm <NumWords>
is         Identify length of scan chain select register
ms         Measure length of scan chain. Syntax: ms <Scan chain>
mr         Measure RTCK react time. Syntax: mr
q          Quit
qc         Close JLink connection and quit
eoe        Exit on error
             Syntax: eoe <1/0>
r          Reset target         (RESET)
rx         Reset target         (RESET). Syntax: rx <DelayAfterReset>
RSetType   Set the current reset type. Syntax: RSetType <type>
Regs       Display contents of registers
wreg       Write register.   Syntax: wreg <RegName>, <Value>
rreg       Read register.    Syntax: wreg <RegName>
moe        Shows mode-of-entry, meaning: Reason why CPU is