使用MfgTool烧写imx6ull启动失败（已解决）

烧写自制的系统，发现无法启动：

错误信息如下：发现是设备树名称错误，于是重命名了设备树文件，问题解决。

U-Boot 2016.03 (Jul 12 2020 - 12:35:07 +0800)
​
CPU:   Freescale i.MX6ULL rev1.1 69 MHz (running at 396 MHz)
CPU:   Industrial temperature grade (-40C to 105C) at 40C
Reset cause: POR
Board: MX6ULL ALIENTEK EMMC
I2C:   ready
DRAM:  512 MiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
*** Warning - bad CRC, using default environment
​
Display: TFT7016 (1024x600)
Video: 1024x600x24
In:    serial
Out:   serial
Err:   serial
switch to partitions #0, OK
mmc1(part 0) is current device
Net:   FEC1
Error: FEC1 address not set.
​
Normal Boot
Hit any key to stop autoboot:  0
switch to partitions #0, OK
mmc1(part 0) is current device
switch to partitions #0, OK
mmc1(part 0) is current device
reading boot.scr
** Unable to read file boot.scr **
reading zImage
5582792 bytes read in 138 ms (38.6 MiB/s)
Booting from mmc ...
reading imx6ull-alientek-emmc.dtb
** Unable to read file imx6ull-alientek-emmc.dtb **
Kernel image @ 0x80800000 [ 0x000000 - 0x552fc8 ]
​
Starting kernel ...
​