NR/5G - PDSCH调度的一些限制

---

 

协议描述中经常可以看到这样的描述“The UE is not extpected to ……”，UE不期望接收到……的调度，是对调度做了一些限制。

 

在38.214的5.1节中，对PDSCH的调度也做了一系列的限制。

 

 

​

For any HARQ process ID(s) in a given scheduled cell, the UE is not expected to receive a PDSCH that overlaps in time with another PDSCH.

这里针对的主要是需要进行HARQ-ACK反馈的PDSCH，在HARQ-ACK的Semi-static反馈方式介绍（TypeI -- Semi-static HARQ-ACK比特数确定）中，为了减少反馈比特数，会把PDSCH时域重叠的Candidate进行一些合并处理。

 

---

The UE is not expected to receive another PDSCH for a given HARQ process until after the end of the expected transmission of HARQ-ACK for that HARQ process, where the timing is given by Subclause 9.2.3 of [6].

在下行进程的HARQ-ACK反馈之前，不能继续调度该下行进程，需要一来一回调度，这里指的是不配置pdsch-AggregationFactor，同一个进程进行多次传输的场景。

 

---

 In a given scheduled cell, the UE is not expected to receive a first PDSCH in slot i, with the corresponding HARQ-ACK assigned to be transmitted in slot j, and a second PDSCH starting later than the first PDSCH with its corresponding HARQ-ACK assigned to be transmitted in a slot before slot j.

 

不同下行进程之间，不能插队，先来先反馈。

 

---

For any two HARQ process IDs in a given scheduled cell, if the UE is scheduled to start receiving a first PDSCH starting in symbol j by a PDCCH ending in symbol i, the UE is not expected to be scheduled to receive a PDSCH starting earlier than the end of the first PDSCH with a PDCCH that ends later than symbol i.

理解还是PDCCH先调度，则对应PDSCH先来的原则吧。

 

---

The UE is not expected to decode a PDSCH scheduled with C-RNTI, MCS-C-RNTI, or CS-RNTI if another PDSCH in the same cell scheduled with RA-RNTI partially or fully overlap in time.

 

The UE is not expected to decode a PDSCH scheduled in a serving cell with C-RNTI or MCS-C-RNTI and another PDSCH scheduled in the same serving cell with CS-RNTI if the PDSCHs partially or fully overlap in time.

 

 

记得在LTE里面，如果需要检测RA-RNTI时候，LTE描述“When RA-RNTI andeither C-RNTI or SPS C-RNTI are assigned in the same subframe, UE is notrequired to decode a PDSCH indicated by a PDCCH with a CRC scrambled by C-RNTIor SPS C-RNTI”，在同一个子帧C-RNTI /SPS C-RNTI PDSCH是可以不进行译码的。

 

另外一个方面考虑问题，RA-RNTI与C-RNTI会同时接收的场景，在连接态下，SR Fail之后的RACH申请上行调度是一种场景？此时UE上下行链路有可能属于正常状态，无上行发送，基站还会一直给UE调度下行？

 

C-RNTI/MCS-C-RNTI PDSCH与CS-RNTI PDSCH不能时域重叠，个人理解在第一个图里面应该包含了。

The UE in RRC_IDLE and RRC_INACTIVE modes shall be able to decode two PDSCHs each scheduled with SI-RNTI, P-RNTI, RA-RNTI or TC-RNTI, with the two PDSCHs partially or fully overlapping in time in non-overlapping PRBs.

在RRC_IDLE和RRC_INACTIVE下，PDSCH可以时域在符号上进行重叠的，在频域上是分开的。这里SI-RNTI/RA-RNTI/P-RNTI不需要进行HARQ-ACK反馈的，唯一的例外是TC-RNTI PDSCH，在竞争解决成功的时候，需要反馈1比特ACK。

 

---

On a frequency range 1 cell, the UE shall be able to decode a PDSCH scheduled with C-RNTI, MCS-C-RNTI, or CS-RNTI and, during a process of P-RNTI triggered SI acquisition, another PDSCH scheduled with SI-RNTI that partially or fully overlap in time in non-overlapping PRBs, unless the PDSCH scheduled with C-RNTI, MCS-C-RNTI, or CS-RNTI requires Capability 2 processing time according to subclause 5.3 in which case the UE may skip decoding of the scheduled PDSCH with C-RNTI, MCS-C-RNTI, or CS-RNTI.

 

On a frequency range 2 cell, the UE is not expected to decode a PDSCH scheduled with C-RNTI, MCS-C-RNTI, or CS-RNTI if in the same cell, during a process of P-RNTI triggered SI acquisition, another PDSCH scheduled with SI-RNTI partially or fully overlap in time.

这里描述的是P-RNTI指示的系统消息更新场景，FR1和FR2调度要求不一样，FR2下SI-RNTI PDSCH和业务数据PDSCH不能时域重叠。FR1则根据UE能力区分。

 

---

In a given scheduled cell, for any PDSCH corresponding to SI-RNTI, the UE is not expected to decode a re-transmission of an earlier PDSCH with a starting symbol less than N symbols after the last symbol of that PDSCH, where the value of N depends on the PDSCH subcarrier spacing configuration m, with N=13 for m=0, N=13 for m=1, N=20 for m=2, and N=24 for m=3.

 

这个调度限制的原因，还没领悟到……

 

---

                                                                                        帮忙同时关注公众号  谢谢！