nrf52840 改变VDD电压

sd_power_dcdc_mode_set(NRF_POWER_DCDC_ENABLE);
sd_power_dcdc0_mode_set(NRF_POWER_DCDC_ENABLE);
set_vol(UICR_REGOUT0_VOUT_3V3);
···
void set_vol(uint8_t vol)//UICR_REGOUT0_VOUT_3V3
{
if (NRF_POWER->MAINREGSTATUS &
(POWER_MAINREGSTATUS_MAINREGSTATUS_High << POWER_MAINREGSTATUS_MAINREGSTATUS_Pos))
{
// Configure UICR_REGOUT0 register only if it is set to default value.
if ((NRF_UICR->REGOUT0 & UICR_REGOUT0_VOUT_Msk) ==
(UICR_REGOUT0_VOUT_DEFAULT << UICR_REGOUT0_VOUT_Pos))
{
NRF_NVMC->CONFIG = NVMC_CONFIG_WEN_Wen;
while (NRF_NVMC->READY == NVMC_READY_READY_Busy){}

    NRF_UICR->REGOUT0 = (NRF_UICR->REGOUT0 & ~((uint32_t)UICR_REGOUT0_VOUT_Msk)) |
                        (vol << UICR_REGOUT0_VOUT_Pos);

    NRF_NVMC->CONFIG = NVMC_CONFIG_WEN_Ren;
    while (NRF_NVMC->READY == NVMC_READY_READY_Busy){}

    // System reset is needed to update UICR registers.
    NVIC_SystemReset();
}
}

}
···

供电电路：