1. 如何测量示波器带宽
这虽然是一个示波器很小的知识点,但是我几乎很少看到会有资料/文档写到这方面的知识。
我在Tek校准/维修的文档上面找到的。
示波器带宽测试操作步骤:
- Set up the oscilloscope using the following steps:
- As shown below, connect the oscilloscope channel selected in the table to the leveled sine wave generator.
-
Set the oscilloscope VOLTS/DIV to 500 mV/div.
-
Set the oscilloscope SEC/DIV to 10us/div.
-
Set the leveled sine wave generator frequency to 50 kHz.
-
Set the leveled sine wave generator output level so the peak-to-peak
measurement is between 2.98 V and 3.02 V.
-
Set the leveled sine wave generator frequency to your oscilloscope bandwidth
-
Set the oscilloscope SEC/DIV to 10 ns/div.
-
Check that the peak-to-peak measurement is ≥2.12 V.
实际上就是大家熟悉的,3dB带宽,
示波器带宽是正弦曲线输入信号被衰减到信号实际幅度的70.7%的频率,称为-3dB点。
2. 要点
(1)垂直时基:对输入信号的振幅,似乎测试中打满了屏幕70-80%
(2)水平时基:时基上面也能显示十几个周期,看起来还很密集。不是1-2个周期。
(3)线缆:测试用的1X探头,BNC接口的同轴线缆,这种同轴线缆很容易达到1G以上的带宽。
(4)信号源:正弦,原因?频谱纯净。
(5)示波器设置:Pk-Pk电压,average 16次,trigger noise?不是边沿?
3. 资料
资料寻找的方法:
仪器厂商国外官网,给一下找资料的关键词:
maintain
service Manual
troubleshooting
而且要找1990~2010年附近的,过早的机器太老。
最新的又不会给非常详细的资料。
欢迎关注我的公众号:沈土豪的书屋