RT-Thread 开启软件IIC

最新推荐文章于 2024-08-08 23:18:23 发布

菁华如风

最新推荐文章于 2024-08-08 23:18:23 发布

阅读量6.8w

点赞数 1

分类专栏：嵌入式文章标签： RT-ThreadStudio 软件IIC 编译错误 board.h 配置

本文链接：https://blog.csdn.net/qq_37253168/article/details/117898056

版权

嵌入式专栏收录该内容

20 篇文章 8 订阅

订阅专栏

使用RT-Thread Studio，点亮软件IIC，

保存后编译，会出现报错，这是因为我们还需要修改board.h，

/*-------------------------- I2C CONFIG BEGIN --------------------------*/

/** if you want to use i2c bus(soft simulate) you can use the following instructions.
 *
 * STEP 1, open i2c driver framework(soft simulate) support in the RT-Thread Settings file
 *
 * STEP 2, define macro related to the i2c bus
 *                 such as     #define BSP_USING_I2C1
 *
 * STEP 3, according to the corresponding pin of i2c port, modify the related i2c port and pin information
 *                 such as     #define BSP_I2C1_SCL_PIN    GET_PIN(port, pin)   ->   GET_PIN(C, 11)
 *                             #define BSP_I2C1_SDA_PIN    GET_PIN(port, pin)   ->   GET_PIN(C, 12)
 */

/*#define BSP_USING_I2C1*/
#define BSP_USING_I2C1
#ifdef BSP_USING_I2C1
#define BSP_I2C1_SCL_PIN    GET_PIN(B, 6)
#define BSP_I2C1_SDA_PIN    GET_PIN(B, 7)
#endif

/*#define BSP_USING_I2C2*/
#ifdef BSP_USING_I2C2
#define BSP_I2C2_SCL_PIN    GET_PIN(port, pin)
#define BSP_I2C2_SDA_PIN    GET_PIN(port, pin)
#endif

如上，需要在board.h中打开 BSP_USING_I2C1（根据项目需求打开对应的I2C宏定义），然后通过修改 BSP_I2C1_SCL_PIN和BSP_I2C1_SDA_PIN来指定I2C使用具体引脚，此时再次编译就不会报错。

下载后，在Finsh中使用list_device命令，可以看到I2C设备已经检测到，