kernel驱动移植过程

1. 扩展CS8900驱动移植方法1(在配置好的本地CS8900驱动基础上修改, 见"挂载最小系统过程.txt": line161~line275)
   /linux-2.6.22.6/drivers/net/cs89x0.c:
   注释line201:
   // #define RM9200_PA_CS8900 0x80000000 //local cs8900
   // static unsigned int cs8900_irq_map[] = {57, 0, 0, 0}; //irq: 57
   添加:
   define RM9200_PA_CS8900 0x40000000 //extend cs8900
   static unsigned int cs8900_irq_map[] = {93, 0, 0, 0}; //extend cs8900:pin124 PB29 IRQ0/93

   修改menuconfig, 关闭nand flash功能(因为nandflash 和 cs8900公用一个base )
   Device Drivers —>
   <*> Memory Technology Device (MTD) support —>
   < > NAND Device Support —>

    Device Drivers  --->
    	Network device support  --->
    		Ethernet (10 or 100Mbit)  --->
    			<*> CS89x0 support
   

   配置u-boot支持扩展cs8900: (需要关闭本地网卡, 配置成扩展网卡, 否则能挂载uImage, 但是不能挂载系统)
   /u-boot-1.3.4/include/configs/at91rm9200dk.h:
   注释line264: // #define CS8900_BASE 0x80000300 /* local CS8900 /
   打开line265: #define CS8900_BASE 0x40000300 / extend CS8900 */
   注释line173: // #define CONFIG_CMD_NAND

    /u-boot-1.3.4/drivers/net/cs8900.c: 
    	注释: 
    		/*Net1(local) init  (another config CS8900_BASE: 0x80000300)
    		//Reset Net1  **is very important
    		AT91C_BASE_PIOB->PIO_OER = 1<<27;
    		AT91C_BASE_PIOB->PIO_CODR = 1<<27;		//low
   
    		//Configure PC13 controllers to periph A mode
    		AT91C_BASE_PIOC->PIO_ASR = 1<<13;
    		AT91C_BASE_PIOC->PIO_BSR = 0x00000000;
    		AT91C_BASE_PIOC->PIO_PDR = 1<<13;
   
    		//Configure CS7
    		AT91C_BASE_SMC2->SMC2_CSR[7] = 0x1100318A;
    		*/
    	打开: 
    		//Net2(extend) init	 (another config CS8900_BASE: 0x40000300)
    		//Reset Net2  **is very important
    		AT91C_BASE_PIOC->PIO_OER = 1<<14;	
    		AT91C_BASE_PIOC->PIO_CODR = 1<<14;		//low
   
    		//Configure CS3
    		AT91C_BASE_SMC2->SMC2_CSR[3] = 0x1100318A;
    		//
   

   保存后重新编译:
   $ make
   $ cp arch/arm/boot/uImage /work/nfs_root/

   修改环境变量:
   U-Boot> setenv bootcmd nfs 20007FC0 10.124.0.45:/work/nfs_root/uImage ;bootm 20007FC0
   U-Boot> setenv bootargs noinitrd root=/dev/nfs nfsroot=10.124.0.45:/work/nfs_root/new_fs_mini ip=10.124.0.33:10.124.0.45:10.124.0.1:255.255.255.0::eth0:off init=/linuxrc console=ttySAC0,115200
   U-Boot> saveenv

   测试, 上电观察串口打印输出:
   …
   cs89x0:cs89x0_probe(0x0)
   cs89x0.c: v2.4.3-pre1 Russell Nelson