MIPI -- Acronyms

ALPS – Alternate Low Power State
BER – Bit Error Rate
CCI – Camera Control Interface
CIL – Control and Interface Logic
CRC – Cyclic Redundancy Check
CSI – Camera Serial Interface
CSPS – Chroma Shifted Pixel Sampling
DDR – Dual Data Rate
DI – Data Identifier
DT – Data Type
ECC – Error Correction Code
EoT – End of Transmission
EPD – Efficient Packet Delimiter (PHY and / or Protocol generated signaling used in LRTE)
EXIF – Exchangeable Image File Format
FE – Frame End
FS – Frame Start
HS – High Speed; identifier for operation mode
HS-LPS-LS – High speed to Low Power State to High speed switching (includes LPS entry and exit latencies)
HS-RX – High-Speed Receiver
HS-TX – High-Speed Transmitter
I2C – Inter-Integrated Circuit
ILR – Interpacket Latency Reduction
JFIF – JPEG File Interchange Format
JPEG – Joint Photographic Expert Group
LE – Line End
LFSR – Linear Feedback Shift Register
LLP – Low Level Protocol
LS – Line Start
LSB – Least Significant Bit
LSS – Least Significant Symbol
LP – Low-Power; identifier for operation mode
LP-RX – Low-Power Receiver (Large-Swing Single Ended)
LP-TX – Low-Power Transmitter (Large-Swing Single Ended)
LRTE – Latency Reduction Transport Efficiency
MSB – Most Significant Bit
MSS – Most Significant Symbol
PDQ – Packet Delimiter Quick (PHY generated and consumed signaling used in LRTE)
PF – Packet Footer
PH – Packet Header
PI – Packet Identifier
PT – Packet Type
PHY – Physical Layer
PPI – PHY Protocol Interface
PRBS – Pseudo-Random Binary Sequence
RGB – Color representation (Red, Green, Blue)
RX – Receiver
SCL – Serial Clock (for CCI)
SDA – Serial Data (for CCI)
SLM – Sleep Mode
SoT – Start of Transmission
TX – Transmitter
ULPS – Ultra Low Power State
VGA – Video Graphics Array
YUV – Color representation (Y for luminance, U & V for chrominance)