一、oled7脚+esp32+micropython_esp32连接7脚(1)

最新推荐文章于 2024-09-12 22:54:05 发布

2301_81749759

最新推荐文章于 2024-09-12 22:54:05 发布

阅读量219

点赞数 2

分类专栏：程序员文章标签：嵌入式

本文链接：https://blog.csdn.net/2301_81749759/article/details/137418148

版权

这篇博客介绍了如何使用ESP32通过Micropython连接7脚OLED屏幕，并提供了屏幕驱动ssd1306.py和hello显示代码oled.py的示例，特别提到了使用软SPI模式进行连接。

摘要由CSDN通过智能技术生成

3V3/5V--------VCC
P18-----------D0
P23-----------D1
P15-----------RES
P2------------DC
P4------------CS

在这里插入图片描述

二、代码编写

1.屏幕驱动ssd1306.py：

# ssd1306.py
#MicroPython SSD1306 OLED driver, I2C and SPI interfaces created by Adafruit
 
import time
import framebuf
 
# register definitions
SET_CONTRAST        = const(0x81)
SET_ENTIRE_ON       = const(0xa4)
SET_NORM_INV        = const(0xa6)
SET_DISP            = const(0xae)
SET_MEM_ADDR        = const(0x20)
SET_COL_ADDR        = const(0x21)
SET_PAGE_ADDR       = const(0x22)
SET_DISP_START_LINE = const(0x40)
SET_SEG_REMAP       = const(0xa0)
SET_MUX_RATIO       = const(0xa8)
SET_COM_OUT_DIR     = const(0xc0)
SET_DISP_OFFSET     = const(0xd3)
SET_COM_PIN_CFG     = const(0xda)
SET_DISP_CLK_DIV    = const(0xd5)
SET_PRECHARGE       = const(0xd9)
SET_VCOM_DESEL      = const(0xdb)
SET_CHARGE_PUMP     = const(0x8d)
 
 
class SSD1306:
    def \_\_init\_\_(self, width, height, external_vcc):
        self.width = width
        self.height = height
        self.external_vcc = external_vcc
        self.pages = self.height // 8
        # Note the subclass must initialize self.framebuf to a framebuffer.
        # This is necessary because the underlying data buffer is different
        # between I2C and SPI implementations (I2C needs an extra byte).
        self.poweron()
        self.init_display()
 
    def init\_display(self):
        fo