1、gen_caltab( : : XNum, YNum, MarkDist, DiameterRatio, CalPlateDescr, CalPlatePSFile : )
为具有矩形排列标记的标定板生成校准板描述文件和相应的后记文件。
XNum (input_control) integer → (integer):每行黑色标志圆点的数量
Number of marks in x direction.
Default value: 7
Suggested values: 5, 7, 9
Recommended increment: 1
Restriction: XNum > 1
YNum (input_control) integer → (integer):每列黑色标志圆点的数量
Number of marks in y direction.
Default value: 7
Suggested values: 5, 7, 9
Recommended increment: 1
Restriction: YNum > 1
MarkDist (input_control) real → (real):两个临近黑色圆点中心的距离单位是meter
Distance of the marks in meters.
Default value: 0.0125
Suggested values: 0.1, 0.0125, 0.00375, 0.00125
Restriction: 0.0 < MarkDist
DiameterRatio (input_control) real → (real):黑色圆点直径与两圆点中心距离的比值
Ratio of the mark diameter to the mark distance.
Default value: 0.5
Suggested values: 0.5, 0.55, 0.6, 0.65
Restriction: 0.0 < DiameterRatio < 1.0
CalPlateDescr (input_control) filename.write → (string):标定板描述文件的文件路径(.descr)
File name of the calibration plate description.
Default value: 'caltab.descr'
List of values: 'caltab.descr', 'caltab_100mm.descr', 'caltab_10mm.descr', 'caltab_200mm.descr', 'caltab_30mm.descr'
File extension: .descr
CalPlatePSFile (input_control) filename.write → (string)z:标定板图像文件的文件路径(.ps)
File name of the PostScript file.
Default value: 'caltab.ps'
File extension: .ps