Let’s look at how the system handles a typical send call when the send buffer size is non-zero. When an application makes a send call, if there is sufficient buffer space, the data is copied into the socket’s send buffers, the call completes immediately with success, and the completion is posted. On the other hand, if the socket’s send buffer is full, then the application’s send buffer is locked and the send call fails with WSA_IO_PENDING. After the data in the send buffer is processed (for example, handed down to TCP for processing), then Winsock will process the locked buffer directly. That is, the data is handed directly to TCP from the application’s buffer and the socket’s send buffer is completely bypassed.
The opposite is true for receiving data. When an overlapped receive call is performed, if data has already been received on the connection, it will be buffered in the socket’s receive buffer. This data will be copied directly into the application’s buffer (as much as will fit), the receive call returns success, and a completion is posted. However, if the socket’s receive buffer is empty, when the overlapped receive call is made, the application’s buffer is locked and the call fails with WSA_IO_PENDING. Once data arrives on the connection, it will be copied directly into the application’s buffer, bypassing the socket’s receive buffer altogether.
Setting the per-socket buffers to zero generally will not increase performance because the extra memory copy can be avoided as long as there are always enough overlapped send and receive operations posted. Disabling the socket’s send buffer has less of a performance impact than disabling the receive buffer because the application’s send buffer will always be locked until it can be passed down to TCP for processing. However, if the receive buffer is set to zero and there are no outstanding overlapped receive calls, any incoming data can be buffered only at the TCP level. The TCP driver will buffer only up to the receive window size, which is 17 KB—TCP will increase these buffers as needed to this limit; normally the buffers are much smaller. These TCP buffers (one per connection) are allocated out of non-paged pool, which means if the server has 1000 connections and no receives posted at all, 17 MB of the non- paged pool will be consumed! The non-paged pool is a limited resource, and unless the server can guarantee there are always receives posted for a connection, the per-socket receive buffer should be left intact.
Only in a few specific cases will leaving the receive buffer intact lead to decreased performance. Consider the situation in which a server handles many thousands of connections and cannot have a receive posted on each connection (this can become very expensive, as you’ll see in the next section). In addition, the clients send data sporadically. Incoming data will be buffered in the per-socket receive buffer and when the server does issue an overlapped receive, it is performing unnecessary work. The overlapped operation issues an I/O request packet (IRP) that completes, immediately after which notification is sent to the completion port. In this case, the server cannot keep enough receives posted, so it is better off performing simple non-blocking receive calls.
WinSocket如何处理一个典型的数据请求
最新推荐文章于 2020-12-14 11:11:53 发布