PCB的检验公差要求

来自前小米PCB工程师对PCB的检验公差分享（仅供参考）：

1. Hole Tolerance (孔的公差) }

1-1. Circular Hole Tolerance (圆孔孔径公差):

NPTH孔(无铜)的孔径公差:±0.05

PTH孔(有铜)的孔径公差:±0.075

1-2. Racetrack Hole Tolerance (跑道形孔):

Width Tolerance 宽度公差±0.05;Length Tolerance 长度公差±0.075

1-3. Hole Center Distance (孔中心距公差):

Normal Tolerance常规±0.075;Minimum Tolerance 极限公差可做到±0.06

2. PCB Thickness Tolerance (PCB板厚公差) }

2-1. T<1mm,Tolerance is ±10% of PCB Thickness.Such as T0.5:±0.05; T0.8:±0.08 厚度小于1mm的PCB,板厚公差为板厚的±10%.例如板厚0.5公差±0.05;板厚0.08公差±0.08

2-2. T=1mm,Tolerance ±0.08 厚度等于1mm的PCB,板厚公差为±0.08

2-3. T>1mm,Tolerance ±0.10 厚度大于1mm的PCB,板厚公差为±0.1

3. PCB Outline tolerance ±0.1 (PCB外形公差±0.1)

4. All Unsepcified Radians (未注圆角R0.5)

5. Screw holes must be drilled. (螺丝孔必须是钻孔)}