基于stm32的呼吸灯

基于stm32的呼吸灯

一.STM32CubeMX设置

1.RCC配置

2.SYS设置

debug修改

3.TIM设置

此处选择TIM1

二.KEIL设置

1.main.c修改

将以下代码替换到main.c中

int main(void)
{
  /* USER CODE BEGIN 1 */
	uint8_t pwm_value=0;   //PWM占空比
  /* USER CODE END 1 */

  /* MCU Configuration--------------------------------------------------------*/

  /* Reset of all peripherals, Initializes the Flash interface and the Systick. */
  HAL_Init();

  /* USER CODE BEGIN Init */

  /* USER CODE END Init */

  /* Configure the system clock */
  SystemClock_Config();

  /* USER CODE BEGIN SysInit */

  /* USER CODE END SysInit */

  /* Initialize all configured peripherals */
  MX_GPIO_Init();
  MX_TIM1_Init();
  /* USER CODE BEGIN 2 */	
  HAL_TIM_PWM_Start(&htim1,TIM_CHANNEL_1);	//使能TIM1的PWM Channel1 输出
  /* USER CODE END 2 */

  /* Infinite loop */
  /* USER CODE BEGIN WHILE */
  while (1)
  {
    /* USER CODE END WHILE */

    /* USER CODE BEGIN 3 */
		
		while (pwm_value < 500)
	  {
		  pwm_value++;
		  __HAL_TIM_SetCompare(&htim1, TIM_CHANNEL_1, pwm_value);    //修改比较值，修改占空比
//		  TIM1->CCR1 = pwm_value;    //与上方作用相同，直接修改寄存器
		  HAL_Delay(1);
	  }
	  while (pwm_value)
	  {
		  pwm_value--;
		  __HAL_TIM_SetCompare(&htim1, TIM_CHANNEL_1, pwm_value);    //修改比较值，修改占空比
//		  TIM1->CCR1 = pwmVal;    	 //与上方作用相同，直接修改寄存器
		  HAL_Delay(1);
	  }
	  HAL_Delay(200);
  }
  /* USER CODE END 3 */
}

2.编译烧录

三.结果

84305BF2F135CCBB43DFEEC960DE