笔记2：STM32学习之EXTI(外部中断篇)

使用EXTI要先设置NVIC;
void NVIC_Configuration()
{
NVIC_InitTypeDef NVIC_InitStructure;
NVIC_PriorityGroupConfig(NVIC_PriorityGroup_0);//选择中断优先级分组
NVIC_InitStructure.NVIC_IRQChannel = EXTI0_IRQn;//设置0管脚为 中断管脚
NVIC_InitStructure.NVIC_IRQChannelPreemptionPriority = 0;//设置先占式优先级
NVIC_InitStructure.NVIC_IRQChannelSubPriority = 0;//设置从占式优先级
NVIC_InitStructure.NVIC_IRQChannelCmd = ENABLE;//使能
NVIC_Init(&NVIC_InitStructure);
}
接着设置EXTI 这里我选择使用EXTI0
void EXTI_Configuration()
{
EXTI_InitTypeDef EXTI_InitStructure;
EXTI_DeInit(); //将EXTI 设置为默认值
GPIO_EXTILineConfig(GPIO_PortSourceGPIOA,GPIO_PinSource0); //选择A0为中断管脚
EXTI_InitStructure.EXTI_Line = EXTI_Line0; //选择0通道
EXTI_InitStructure.EXTI_Mode = EXTI_Mode_Interrupt; //选择为中断
EXTI_InitStructure.EXTI_Trigger = EXTI_Trigger_Falling; //设置沿下降沿中断
EXTI_InitStructure.EXTI_LineCmd = ENABLE; //使能
EXTI_Init(&EXTI_InitStructure);
}
注意完成一次中断后要把中断标准位 清空 使用EXTI_ClearITPendingBit(EXTI_Line0);
而且还要把 复用时钟打开 使用
RCC_APB2PeriohClockCmd(RCC_APB2Periph_AFIO,ENABLE);加粗样式

摘录：http://www.51hei.com/bbs/dpj-33193-1.html