STM32F10xZ 定时器1 PWM调试

GPIO_InitTypeDef GPIO_InitStruct;
		
		RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOE,ENABLE);
		// 开启复用IO
		RCC_APB2PeriphClockCmd(RCC_APB2Periph_AFIO, ENABLE); 
		RCC_APB2PeriphClockCmd(RCC_APB2Periph_TIM1, ENABLE);   			 //使能AHB预分频器到TIM1
		GPIO_PinRemapConfig(GPIO_FullRemap_TIM1,ENABLE);
		// PE9
		GPIO_InitStruct.GPIO_Pin = GPIO_Pin_9;
		GPIO_InitStruct.GPIO_Mode = GPIO_Mode_AF_PP;
		GPIO_InitStruct.GPIO_Speed = GPIO_Speed_50MHz;
		GPIO_Init(GPIOE,&GPIO_InitStruct);
		
		TIM_TimeBaseInitTypeDef TIM_TimeBaseStructure;                   //声明TIM_TimeBaseStructure结构变量
		TIM_OCInitTypeDef TIM_OCInitStructure;                           //声明TIM_OCInitStructure结构变量

		
		TIM_TimeBaseStructure.TIM_Period = 1200;                       //设置TIM1自动重装周期值
		TIM_TimeBaseStructure.TIM_Prescaler = 0;                         //设置TIM1预分频值
		TIM_TimeBaseStructure.TIM_ClockDivision = 0;                     //设置时钟分割
		TIM_TimeBaseStructure.TIM_CounterMode =TIM_CounterMode_Up;       //向上计数
		TIM_TimeBaseStructure.TIM_RepetitionCounter = 0x0;
		TIM_TimeBaseInit(TIM1, &TIM_TimeBaseStructure);                  //按以上参数初始化TIM1

		TIM_OCInitStructure.TIM_OCMode = TIM_OCMode_PWM2;     			 //PWM2模式
		TIM_OCInitStructure.TIM_OutputState = TIM_OutputState_Enable;    //比较输出使能

		TIM_OCInitStructure.TIM_Pulse =500;                              //通道占空比系数
		TIM_OCInitStructure.TIM_OCPolarity = TIM_OCPolarity_Low;		 //输出低
		TIM_OC1Init(TIM1,&TIM_OCInitStructure);                          //按以上参数初始化TIM1

		TIM_OC1PreloadConfig(TIM1, TIM_OCPreload_Enable);        		 //使能预装载寄存器
		TIM_CtrlPWMOutputs(TIM1,ENABLE);
		TIM_Cmd(TIM1, ENABLE);                                           //使能TIM1
		
		TIM_CCPreloadControl(TIM1,DISABLE);// 必须加这句话否则没有波形产生
		TIM_OC1PreloadConfig(TIM1, TIM_OCPreload_Enable);  //使能TIM1在CCR1上的预装载寄存器
		TIM_ARRPreloadConfig(TIM1, ENABLE);                //使能TIMx在ARR上的预装载寄存器
		TIM_Cmd(TIM1, ENABLE);  //使能TIM1	
		TIM_CtrlPWMOutputs(TIM1, ENABLE);//设置PMW主输出
		

 

 最终发现STM32F103ZCT 多个一个bit.