verilog中含有无关项的序列检测

编写一个序列检测模块，检测输入信号a是否满足011XXX110序列（长度为9位数据，前三位是011，后三位是110，中间三位不做要求），当信号满足该序列，给出指示信号match。

程序的接口信号图如下

代码如下：

（CSDN代码块不支持Verilog，代码复制到notepad++编辑器中，语言选择Verilog，看得更清楚）

`timescale 1ns/1ns
module sequence_detect(
	input clk,
	input rst_n,
	input a,
	output match
	);

	reg [8:0] a_tem;
	reg match_f;
	reg match_b;
	
	always @(posedge clk or negedge rst_n)
		if (!rst_n)
			begin 
				match_f <= 1'b0;
			end
		else if (a_tem[8:6] == 3'b011)
			begin
				match_f <= 1'b1;
			end
		else 
			begin	
				match_f <= 1'b0;
			end

	always @(posedge clk or negedge rst_n)
		if (!rst_n)
			begin 
				match_b <= 1'b0;
			end
		else if (a_tem[2:0] == 3'b110)
			begin
				match_b <= 1'b1;
			end
		else 
			begin	
				match_b <= 1'b0;
			end
			
	always @(posedge clk or negedge rst_n)
		if (!rst_n)
			begin 
				a_tem <= 9'b0;
			end
		else 
			begin
				a_tem <= {a_tem[7:0],a};
			end
			
	assign match = match_b && match_f;
endmodule