新版本Jetpack4.5.1 Tx2最大功率模式启动
安装新的Jetpack4.5.1版本后tx2切换最大功率模式
之前公司采购了几块tx2作边缘计算,一块我安装了jetpack4.4版本,另外两块安装的4.5.1版本,发现4.4版本,用指令sudo nvpmodel -m 0,切换到最大功率模式,6块cpu都能工作,运行jetson_clock.sh风扇也能转起来,但是对于两个装了新系统的不行,CPU2和CPU3工作效率始终0%,风扇也不转,找了一圈全是以前的教程,最开始以为板子坏了,后面到nvidia.developer论坛上去提问才知道好像4.4.1版本后默认禁止了两个cpu运行,必须更改对应的配置文件才行。
官方回答:
If you run command “cat /proc/cmdline”, do you see something like “isolcpus=1-2”? If so, then this is why. You can disable that by editing “/boot/extlinux/extlinux.conf”. If you see “isolcpus=1-2” near the end, then remove the “1-2” so it truncates without mentioning “1-2” (this is the same as removing isolcpus, but if isolcpus exists somewhere else, then it overrides the other isolcpus).
总结下就是更改/boot/extlinux/extlinux.conf文件,把"isolcpus=1-2"改成"isolcpus="就ok。
保存后重启tx2,检查cpu,6核正常工作,OK。
最后强烈建议安装jetson-stats查看jetson板子状态,可以在这个软件中调整风扇!!!
#安装
sudo -H pip install jetson-stats
#使用
sudo jtop
感觉现在网上搜到的jetson资料都过时很久了,新的资料还是得去官方论坛看看。。。