Capture 17.2 的 capture.ini文件路径

最新推荐文章于 2023-10-28 10:25:56 发布

原创最新推荐文章于 2023-10-28 10:25:56 发布 · 3.4k 阅读

4 ·

CC 4.0 BY-SA版权

文章标签：

#蓝牙 #fpga #安全

EDA 专栏收录该内容

1 篇文章

订阅专栏

本文介绍了如何定位不同版本OrCAD Capture的配置文件Capture.ini的位置。对于16.5及更早版本，该文件位于安装目录下；而16.6及后续版本则需要通过Capture程序内的会话日志查看具体路径。

摘要生成于 C知道，由 DeepSeek-R1 满血版支持，前往体验 >

参考网址
https://techsupport.ema-eda.com/support/solutions/articles/48000987971-configure-the-capture-ini-file-for-schematic-parts-and-pcb-footprints

CAPTURE.INI file location:

针对16.5及更老版本
*For Capture version 16.5 and earlier:
The CAPTURE.INI file is in located in the Capture directory. The default install location is “C:\OrCAD\OrCAD_\tools\Capture” or “C:\Cadence\SPB_\tools\Capture”. Be sure to close Capture before editing the CAPTURE.INI file.

针对16.6及更新版本
*For Capture version 16.6 and later:
The CAPTURE.INI file location can be found by opening Capture and looking at the 1st line of the Session Log. This is generally located at the bottom of the Capture window or, from the Menu bar, select ‘Window \ 1 Session Log’. This line will look similar to one of the following paths. However, each user’s installation can vary.

CAPTURE.INI file location:

C:\Cadence\SPB_Data\cdssetup\OrCAD_Capture/17.2.0/Capture.ini,
或者
C:\Cadence\SPB_Data\cessetup\OrCAD_Capture/17.4/Capture.ini

本文完